AMEGAT PBQ2610 Power Bank 140W User Manual
- June 15, 2024
- AMEGAT
Table of Contents
- Charging Your USB Devices
- Charging Your USB Devices Recharging Your Power Bank
- LCD screen guide
- Input Attenuation
- Output Attenuation
- Temperature Protection Warning
- Product care and precautions
- FCC WARNING
- Specifications
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
AMEGAT PBQ2610 Power Bank 140W User Manual
Charging Your USB Devices
Charging Your USB Devices Recharging Your Power Bank
LCD screen guide
Input Attenuation
140W recharging, drop to 100W after 3 min.
>40℃, down to 65W; >42℃, down to 30W.
140-W-Aufladung, Abfall auf 100 W nach 3 Minuten.
40℃, bis 65W; >42℃, bis zu 30W.
Output Attenuation
One port 140W charging, >50℃, down to 100W; >55℃, down to 65W.
Dual ports 130W total charging, >55℃, USB-C 1 turns off.
Ein Port 140 W Laden, > 50 ℃, bis zu 100 W; >55℃, bis zu 65W.
Dual-Ports, 130 W Gesamtladung, >55 ℃, USB-C 1 schaltet sich aus.
Temperature Protection Warning
-
Battery cells reach 60℃ and charging stops
-
Battery cells reach 45℃ and recharging stops
-
Battery cells below 0 ℃
-
Battery cells below -15 ℃
Product care and precautions
- Do not impact or drop the product.
- Keep away from liquids and extreme heat.
- Recharge the power bank at least once every 3 months.
- Do not leave the product in the car for a long time.
- Do not disassemble or modify
Please stop using the product immediately and contact the support center in the following cases.
- The product emits smoke
- The product leaks liquid
- The product has an abnormal smell such as burnt smell
Batteries should be disposed of according to local environmental law
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure statement.
The device can be used in portable exposure condition without restriction
This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Specifications
-
Model: PBQ2610
-
Battery capacity: 27600mAh (4600mAh x 6PCS) / 99.36Wh (21.6V)
-
Rated capacity: 16500mAh
-
Battery type: Lithium-ion
-
Input: USB-1/2 (C): 5V 3A / 9V 3A / 12V 3A / 15V 3A / 20V 5A / 28V 5A / 140W(Max)
-
Output: USB-1/2 (C): 5V 3A / 9V 3A / 12V 3A / 15V 3A / 20V 5A / 28V 5A / PPS: 3.3-21V 5A / AVS: 15-28V 5A / 140W(Max) USB-1 (A): 5V 3A / 9V 2A/ 12V 1.5A / 10V 2.25A /
22.5W(Max)
USB-1 (C)+USB-2 (C): 65W+65W
USB-1 (C)+USB-1 (A): 100W+22.5W
USB-2 (C)+USB-1 (A): 100W+22.5W
USB-1 (C)+USB-2 (C)+USB-1 (A): 60W+60W+18W -
Total output: 140W
-
Operating temperature: 0-40℃ / 32-104℉
-
Storage temperature: -10-40℃ / 14-104℉
-
Dimensions: 153 x 53 x 50mm / 6.02″ x 2.09″ x 1.97″
-
Weight: 643g / 22.68oz
SHENZHEN AUTRAL TECHNOLOGY INNOVATION CO., LTD.
6Q, GUANGLONG BUILDING, NO. 162 NORTH PINGXIN ROAD,
PINGHU, LONGGANG, SHENZHEN 518000, CHINA
FACEBOOK PAGE:
WWW.FACEBOOK.COM/AMEGATOFFICIAL
EMAIL: SUPPORT@AMEGAT.COM
WEB: WWW.AMEGAT.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>