AMEGAT PBW1010 Power Bank User Manual
- June 9, 2024
- AMEGAT
Table of Contents
USER MANUAL
PBW1010
Charging Your Phone or Tablet Using Charging Cables
Charging Your Phone Wirelessly
Ready to wireless charge
Charging
Foreign object detected
Charging Your Smart Watch or Bluetooth Earphones
- Enter low-current charging mode: Press and hold the power button for 3 seconds, and three white LED lights turn on and off alternatively every 6 seconds.
- Charge your smart watch, Bluetooth earphones, or other low-power accessories.
3 Exit low current charging mode: Press and hold the power button for 3 seconds.
Charging Devices Wirelessly and Using Cables Simultaneously
Recharging Your PBW1010
Notes
The USB-C port supports USB Power Delivery fast charging for iPhone 8 and later when used with a certified Apple USB-C to Lightning cable.
- This product can provide perfect magnetic alignment for iPhone 12 / 13 / 14.
- This product can provide up to 7.5W for Qi-compatible iPhone models and up to 15W for certain Android devices.
Product care and precautions
-
Do not impact or drop the product.
-
Keep away from liquids and extreme heat.
-
Recharge the power bank at least once every 3 months.
-
Do not leave the product in the car for a long time.
-
Do not disassemble or modify.
-
Please stop using the product immediately and contact the support center in the following cases.
– The product emits smoke
– The product leaks liquid
– The product has an abnormal smell such as burnt smell -
Batteries should be disposed of according to local environmental law.
This product complies with the radio interference requirements of the European Community.
Declaration of Conformity
This product is intended for use within Europe. This equipment compiles with
the essential requirements for the Radio Equipment Directive 2014/53/EU. AUKEY
Technology Co., Ltd.
hereby declares that this product PBW1010 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU,
2014/35/EU, 2014/30/EU. The Declaration of Conformity for the PBW1010 is
available from www.aukey.com
This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help. FCC RF
exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance between 20cm the radiator your body.
Specifications
| Model | PBW1010 |
|---|---|
| Battery capacity | 10000mAh / 38.5Wh |
| Rated capacity | 6400mAh |
| Battery type | Lithium polymer |
| Input | USB-C: 5V 3A / 9V 2A /12V 1.5A (18W Max) |
| Output | USB-C: 5V 3A / 9V 3A / 12V 2.5A /15V 2A (30W Max) |
Wireless: 15W (Max) / 10W / 7.5W / 5W
Total output| 30W
Operating temperature| 0~40 ℃
Storage temperature| -10-45 ℃
Dimensions| 109 x 68 x 19.2mm /4.29″ x 2.68″ x 0.75″
Weight| 210g / 7.41oz
SHENZHEN AUTRAL TECHNOLOGY INNOVATION CO., LTD.
6Q, GUANGLONG BUILDING, NO. 162 NORTH PINGXIN ROAD,
PINGHU, LONGGANG, SHENZHEN 518000, CHINA
FACEBOOK PAGE:
WWW.FACEBOOK.COM/AMEGATOFFICIAL
EMAIL: SUPPORT@AMEGAT.COM
WEB: WWW.AMEGAT.COM