JONARD TOOLS UST-500 Universal Cable Stripping Tool Instructions
- June 4, 2024
- JONARD TOOLS
Table of Contents
UST-500 Universal Cable Stripping Tool
Instructions
UST-500 Universal Cable Stripping Tool
INSTRUCTIONS:
For Coax Cable
-
Reversible cassette for RG59/6 and 7/11-push to change.
-
Insert cable up to the cable guide
-
Rotate cable counter-clockwise using finger ring 3-5 times, open jaws, and remove the cable. Pull the outer jacket off the cable.
For Round Networking Cable -
Insert cable in the second stripping hole. Rotate cable counterclockwise using finger ring 1-3 times, open jaws, and remove the cable. Pull the outer jacket off the cable.
For Cutting Cable -
Insert cable in the third slot and squeeze For Flat Cable Insert the cable between the stripping blades. Squeeze handles-be sure to keep cables perpendicular, then pull.
-
Insert 4P/6P cable into the two-bladed side of the tool’s stripper until it touches the guide. Insert 8P cable into the two-bladed side of the tool’s stripper and let it extend a little past the lower cut blade.
-
The tool has a black velcro strip for folding back the braided shield of the cable.
Tel 914.793.0700
Fax 914.793.4527
jonard.com