PIKO 55821-90-7002 Smart Control Wlan Basic Set Instruction Manual

: June 15, 2024
: PIKO

Table of Contents

PIKO 55821-90-7002 Smart Control Wlan Basic Set Instruction Manual
Setup:
ATTENTION:
Locomotive selection:
Driving:
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PIKO 55821-90-7002 Smart Control Wlan Basic Set Instruction Manual

Setup:

First connect the main track output (Main) of the PIKO SmartBox wlan to the main track. Now switch on the operating voltage by plugging the power supply unit into a socket.
Now insert the enclosed battery into the battery compartment on the back of the PIKO SmartController wlan. Please note the battery con7ill now switch on automatically. With the battery already inserted and the controller switched off, press and hold the„STOP“ button for approx. 3 seconds to switch it on.

ATTENTION:

The Controller and SmartBox are not paired ex factory. There is no WLAN connection and the WLAN symbol in the controller display is crossed out! The first step must now be to activate the WLAN connection (pairing). If the units are in the delivery state, please follow the instructions in the display of the controller and press and hold the II button on the con- trol unit until the LEDs „Run“ and „Stop/Fail“ flash synchro- nously. Then confirm the queries on the controller with „Yes“ by pressing the „OK“ key within 30 seconds. Use the „left“ or„right“ buttons to switch between „Yes“ and „No“. The con- nection is established when the two LEDs on the control unit stop flashing and the active WLAN symbol appears on the con- troller. After pairing, the locomotive selection menu appears in the display and the „STOP“ button flashes (track voltage switched off).

Locomotive selection:

Loco / right Numeric keypad

delivery of a PIKO SmartControl wlan start set, you can now rerail the locomotive from the set and switch on the track voltagevia the „STOP“ button. Since the vehicles from the start sets are RailCom Plus® capable, your vehicle now automatically re- gisters in the system. Now you can immediately start operation on your model railway.
In the PIKO SmartControl wlan #55821, which is not from a start set, a „Locomotive 3“ is stored with the standard address 3 and 29 functionsThe right cursor button [ ] with the locomotive symbol on it takes you back to the locomotive selection menu.
All other digitalised DCC locomotives, which are not included in the locomotive menu of a PIKO SmartControl wlan or are not RailCom Plus® capable, must first be created in the locomotivedatabase via the edit menu [ ] of the PIKO SmartController wlan
(for more information, please refer to the operating instructions).

Driving:

By turning the throttle’s dial you can control the speed of the selected locomotive. Pressing the dial sets the speed to zero and pressing it again reverses the driving direction. A quick double press on the dial triggers an emergency stop command, which causes the locomotive to stop without braking delay.
The light and up to nine other special functions can be swit- ched directly via the numeric keys, whereby the mapping se- quence of the functions corresponds to the keys on the Num- ber pad. Further functions can be called up using the up/down buttons and switched using the numeric buttons, provided that they are available in the called-up vehicle.

Legal information

Declaration of EU conformityPIKO Spielwaren GmbH hereby declares that the product complies with the 2014/53/EU directive. The complete text of the EU Declaration of Conformity is available at the following Internet address: https://www.piko.de/konform
Seriennummer PIKO SmartBox wlan :
Seriennummer PIKO SmartController wlan :
Radio frequencies and transmission power WLAN 2.4 GHz