ThermElc TE-03TH Temperature and Humidity Data Logger User Manual

: June 15, 2024
: ThermELC

Table of Contents

Product Introductions
Main Feature
First Time Set Up
Quick Start
Operation Functions
LCD Display Description
Battery Replacement
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TE-03 ETH
Temperature and Humidity
Data Logger
User Manual

Product Introductions

ThermElc TE-03 ETH is used for monitoring temperature and humidity of the sensitive goods during storage and transportation. After the recording is finished, the ThermElc TE-03 ETH is connected to any USB port and automatically generates a PDF & CSV report with the temperature and humidity logging results. No additional software is required to read out the ThermElc TE-03 ETH.

Main Feature

Multiple use temperature & humidity logger
External sensor and bracket
Auto generates PDF reports
Auto generates CSV reports
Logging of 34560 points
Recording Interval of 10 seconds to 99 hours
No special device driver required
Temperature and humidity over-limit alarm

ThermElc TE-03TH Temperature and Humidity Data Logger -
parts

First Time Set Up

Open your Internet browser and type in thermelc.com. Navigate to the menu bar,click on ‘Manuals & Software’.
Select the appropriate software for your model. Click on the download link or the model picture to access the software download page.
Once the download is complete,click on the downloaded file to initiate the installation. Follow the steps to complete the installation process.
After installation, you can access the Temperature Management Software. by clicking on the shortcut icon on your desktop.
Full video instructions please go to youtube.com/@ thermelc 2389 Click Playlists – How to use your ThermELC Data logger

Quick Start

Quick start
ThermElc TE03https://www.thermelc.com/pages/ download config your parameter| |
---|---|---
ThermElc TE-03TH Temperature and Humidity Data Logger -
parts5 | | https://www.thermelc.com/pages/contact-us

Operation Functions

Start Recording
Press and hold the START button for approximately 3sec.The OK light is on and the ( ) or (WAIT) on screen indicates the logger is started.
Mark
When the device is recording, press and hold the START button for more than 3sec, and the screen will switch to the “MARK’ interface. The number of MARK’ will increase by one, indicating data was marked successfully.
Stop Recording
Press and hold the STOP button for more than 3sec until the STOP ( ) symbol displays on the screen, indicating stopping recording successfully.
Switch the display
Shortly press START button to switch to different display int- erface. The interfaces shown in sequence are respectively: Real-time Temperature > Real- time Humidity > LOG > MARK > Temperature Upper Limit > Temperature Lower Limit

Humidity Upper Limit > Humidity Lower Limit.
Get Report
Connect the data logger to PC via USB, and it will auto-generate PDF and CSV reports.

LCD Display Description

ThermElc TE-03TH Temperature and Humidity Data Logger -
parts8

| Data logger is recording
---|---
| Data logger has stopped recording
WAIT| Data logger is in Start Delay status
| Temperature and Humidity is within the limited range
X & ↑ H1/H2| Measured value exceeds its upper limit
X & ↓ H1/H2| Measured value exceeds its lower limit