ThermElc TE-02 Temperature Data Logger User Manual

: June 14, 2024
: ThermELC

Table of Contents

ThermElc TE-02 Temperature Data Logger
Product Introductions
Main feature
Quick start
Configuration of a ThermElc TE-02
Operation Functions
LCD Display Instructions
Battery Replacement
Technical Specifications
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ThermElc TE-02 Temperature Data Logger

ThermElc-TE-02-Temperature-Data-Logger-PRODUCT

Product Introductions

ThermElc TE-02 is used for monitoring temperature of the sensitive goods during storage and transportation. After the recording is finished, the ThermElc TE-02 is connected to any USB port and automatically generates a PDF report with the temperature logging results. No additional software is required to read out the ThermElc TE-02.

Main feature

Multiple use logger
Auto PDF logger
Auto generate CSV reports
Logging of 32,000 values
Interval of 10 seconds to 18 hours
No special device driver required
MKT alarm and Temperature Alarm

$ThermElc-TE-02-Temperature-Data-Logger-FIG- $1$$

PLEASE NOTE:
After the device is configurated for the first time or after re-configuration, please leave the device in an open environment over 30 minutes. This will ensure the device is calibrated with the accurate current temperature

Quick start

$ThermElc-TE-02-Temperature-Data-Logger-FIG- $8$$

Software Download

https://www.thermelc.com/pages/download config your parameter

Helpshttps://www.thermelc.com/pages/contact-us

Configuration of a ThermElc TE-02

The device can be configured using the free Data Management software.

Time zone: UTC
Temperature scales: ℃ /℉
Screen display: Always on / Timed
Log interval: 10 to 18 hours
Start delays: 0/ timed
Stop mode: Press button/ disabled
Time format: DD/MM/YY or MM/DD/YY
Start mode: Press button or Timed
Alarm setting: Upper Limit and Lower Limit
Description: Your reference which will appear on the report

Operation Functions

Start Recording
Press and hold the PLAY ( ) button for approximately 3sec.The ‘OK’light is on and the ( ) or ( WAIT ) indicates the logger is started.
Mark
When the device is recording, press and hold the PLAY ( ) button for more than 3sec, and the screen will switch to the ‘MARK’ interface. The number of ‘MARK’ will increase by one, indicating data was marked successfully.
( Note :One record interval can mark one time only, the logger can mark 6 times in one recording trip. Under the status of start delay, the mark operation is disabled.)
Stop Recording
Press and hold the STOP ( ) button for more than 3sec until the ‘ALARM’ light is on, and the STOP ( ) symbol displays on the screen, indicating stopping recording successfully. (Note: If the logger is stopped during the status of start delay, a PDF report is generated when inserted into PC but without data.) During the normal recording process, press PLAY ( ) to switch to a different display interface.
The interfaces shown in sequence are respectively: Realtime Temperature > LOG > MARK > Temperature Upper Limit > Temperature Lower Limit.
Get Report
Connect logger to PC via USB, and it will auto-generate PDF and CSV file