SEALEY LED1000 10W COB LED Rechargeable Pocket Floodlight 1000 Lumens User Manual

June 15, 2024
SEALEY

**SEALEY LED1000 10W COB LED Rechargeable Pocket Floodlight 1000 Lumens User Manual

**

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE

Refer to
instruction.

SAFETY

GENERAL

  • Ensure the lamp is fully charged before initial use.
  • DO NOT turn the lamp on when it is being charged.
  • DO NOT shine directly into your, another person’s or an animal’s eyes.
  • DO NOT allow children to use the lamp.
  • DO NOT handle or move the lamp whilst it is being charged.
  • DO NOT use the lamp if you suspect that the battery, the lamp casing or the cable is damaged. Consult your Sealey Stockist.
  • DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use

BATTERY SAFETY

  • WARNING! To reduce the risk of burns or fire:
  • DO NOT Attempt to open, dismantle, modify or service the battery pack.
  • DO NOT Crush, puncture, short external contacts or dispose of in fire or water.
  • DO NOT Expose to temperatures above 40°C or below -10°C.
  • DO NOT Expose to direct sunlight for long periods of time.
  • DO NOT Expose to moisture.
  • WARNING! DO NOT place the lamp face down while in use.
  • If the electrolyte in the cells gets on your skin, wash thoroughly with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

INTRODUCTION

Compact, lightweight design with a large 1000lm output. Made with a tough ABS plastic housing with flip-out magnetic bracket. Includes small carabiner, which can be used when no ferrous surface is available fordditional storage and application solutions. Magnetic bracket can be angled at a range of 180° making it simple and easy to direct up to 1000 lumens of light. Three light output settings; low, high and flashing. Features LED battery level indicator. Fitted with a high quality 3.7V 2Ah lithium polymer battery. Charges via a USB-C lea Supplied, with charge time of 4 hours). IP rating: IPX

SPECIFICATION

Model No.:…………………… LED1000
Battery: ………………………3.7V 2Ah Li-Poly
Charging Time: …………….4hr
IP Rating ……………………. IPX4
LED Type: …………………. 10W COB
Length:………………………. 9cm
Lumen Output ……………… 1000lm
Operating time: …………4.5hr

The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time. We will provide warranty against mechanical and electrical defect for a period of one year. This does not cover fair wear and tariff the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the battery regardless of whether it is less than one year old.
NOTE : The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another charge.
INTRODUCTION

OPERATION

CHARGING
Insert the Micro USB plug on the USB cable into the charging port on the side of the lamp. Plug the other end of the USB cable into a 5V USB outlet.
WARNING! DO NOT turn lamp on whilst charging The battery indicator will blink blue during charging. As the battery charges it will indicate 25% flashing blue light 50%, flashing blue light, 75% flashing blue light, 100% flashing blue light until the battery has charged fully and all remain solid.
USE OF LAMP
Direct the lens away from your eyes, other people and animals before switching on. Push the ON/OFF switch once for half power mode, twice for full power mode and a third time for flashing mode.
The lamp may be held by the handle or attached to any ferrous surface by using the magnet.
IMPORTANT : Only use the cable supplied with the product.
POWER BANK
Insert the USB plug from the remote device into the charging port on the side of the lamp. The LED on the lamp will be lit blue while charging the remote device.

MAINTENANCE

Clean the casing externally (not the glass) with a moist cloth.
If necessary clean the glass with an alcohol dampened soft cloth.

  • DO NOT use solvents or abrasives.
  • DO NOT allow unit to get wet or use/store in a damp environment.

ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling center and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations

REGISTER YOUR PURCHASE HERE

WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealy Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealy Ltd.’s Batteries Producer Registration Number (BPRN) is BPRN00705.

Note : It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice
Important : No Liability is accepted for incorrect use of this product.
Warranty : Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealy Group, Kimpson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

  01284 757500
sales@sealey.co.uk
www.sealey.co.uk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SEALEY User Manuals

Related Manuals