elk HOME 90005-3 Gladwyn 3 Light Outdoor Post Light Installation Guide
- June 15, 2024
- elk HOME
Table of Contents
elk HOME 90005-3 Gladwyn 3 Light Outdoor Post Light
WARNING
DISCONNECT POWER AT THE MAIN FUSE BOX BEFORE INSTALLATION.
WARNING
This fixture is intended for installation by the National Electrical Code
(NEC) and all local code specifications. If you are not familiar with code
requirements, installation by a certified electrician is recommended. Before
assembly, remove all parts and part packages from the box. If anything is
missing, please contact the retailer from which the product was purchased.
Installation
-
Carefully lower fixture (A) down over the top of the post. Allow fixture (A) to sit on the post.
-
Mark the position of holes in the post mount onto post.
-
Remove fixture and set aside.
-
Drill a 3/16″ hole at each marked location on the post.
-
Strip 3/4” of insulation from ends of fixture wires.
-
Twist end of fixture ground wire (bare copper) and end of house ground wire (copper) together. Twist wire nut (C) onto ends of wires. Completely tighten wire nut (C).
-
Twist end of house lead wire (black) and end of fixture lead wire together. Twist wire nut (C) onto ends of wires. Completely tighten wire nut (C).
-
Twist end of house neutral wire (white) and end of fixture neutral wire together. Twist wire nut (C) onto ends of wires. Completely tighten wire nut (C). Reference charts below.
-
Wrap electrical tape (not included) around wirenuts (C) and wires. Ensure wires are securely fastened into wire nuts.
-
Carefully push wires down into post.
-
Place fixture down over post. DO NOT pinch wires between fixture and post.
-
Align holes in post mount of fixture with holes in post.
-
Thread one fixture mounting screw (E) into each hole in post mount and into post. Tighten fixture mounting screws (E) to secure fixture to post.
-
Ensure that clips along top inside of cage are pressed upward to allow glass panels (K) to fit behind clips.
-
Carefully place one glass panel (K) inside cage. Set bottom edge of glass panel (K) into channel along bottom of one side of cage. Carefully push glass panel (K) against side of cage.
-
Fit top edge of glass panel (K) behind clip along top edge of side of cage. Carefully press clip down against glass panel (K) to hold glass panel (K) in place.
-
Repeat step 14 for the remaining glass panels (K).
-
Screw recommended bulbs (E12 candelabra bulb type, not included) into sockets. Verify correct bulb wattage marked on socket of fixture.
WARNING: DO NOT exceed maximum bulb wattage. -
Lower cage down over bulbs. Place cage (D) on top of fixture (A). Align holes in underside of cage withholes in fixture (A).
-
Thread one small screw (F) into each hole in the fixture (A) and into holes along bottom of cage (D). Tighten small screws (F) to secure cage in place. DO NOT over tighten.
MAINTENANCE NOTE
Only use a soft damp cloth to clean the fixture as needed. DO NOT use harsh chemicals on fixture. Harsh chemicals may damage fixture. Coastal conditions may cause mineral and residue build-up on fixture. It is recommended that customers in coastal areas clean all external surfaces of fixtures once every two weeks with a wet cloth.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>