SOLAX POWER X1 Boost Solar Power Inverter Installation Guide
- May 15, 2024
- SOLAX POWER
Table of Contents
SOLAX POWER X1 Boost Solar Power Inverter
Packing Lists
For the optional accessories, please be subject to the actual delivery.
Inverter Installation
- Unscrew the bracket from the back of the inverter.
- And mark the position(223 mm*30 mm) of three holes
- PH1 cross screwdriver; Torque: 0.8±0.1 N.m
- Drill holes with φ10 drill.
- Depth: at least 60 mm
- Tighten the expansion bolts.
- Screw the expansion screws.
- Match the inverter with the bracket.
- Screw the cross-recessed screw on the right side.
- make sure available space
PV Connection
AC Connection
- Slide the cable nut and back shell onto the cable.
- Insert the stripped end of each three wires into holes in the female insert, then tighten each screw.
- Screw down the threaded sleeve of the pressure screw
- Screw down the pressure screw.
- Connect the AC plug to the inverter.
Firmware Upgrading
- Make sure the DC switch is off and the AC is disconnected from the grid.
- Users can update the inverter system through the U-disk.
- Please contact SolaX service to get the latest firmware. Then add a new folder named “Update” in the root directory on your U-disk, and two more sub-folders named “ARM” and “DSP” under “Update”. Please copy the firmware files into ARM and DSP respectively. It will be like:
- “Update\ARM\618.00207.00_XX_XXXXX_XXXX_XXX_ARM_Vx.xx_xxxxxxxx.usb”;
- “Update\DSP\618.00381.00_XX_XXXXX_XXXX_XXX_DSP_Vx.xx_xxxxxxxx.usb”
- Press and hold the “v” key for 5 seconds to enter Off Mode. Then insert the U-disk into the “DONGLE” port.
Connections and Overview
- Screw the ground screw with Φ4 hexagon wrench shown as follow.
- Prepare the RJ45 connector and the communication cable, following the PIN definition and assembly order below, then insert the RJ45 connector into the corresponding RS485 port of the inverter, and tighten the waterproof connector.
- Overview for connection.
- After checking all connections are correct, turn on the external DC /AC breakers>
- Turn on the DC switch to the “ON” position.
- The inverter will start automatically when PV panels generate enough energy.
- The LED will be blue and the LCD screen will display the main interface.
Firmware Upgrading
For the inverter with LCD, the user can refer to the following:
- When the user turns on all the switches, the LCD will show pictures as below.
- At the same time, the user can choose the program you need by pressing short Up and Down, and long press “V” to confirm and upgrade the inverter.
- After the upgrade is complete, please remember to turn off the DC switch and AC switch, then pull off the Udisk.
- Please contact our service support to get the latest firmware, and unzip it into your U-disk by following the steps above.
- Do not modify the firmware file name! Otherwise, it may cause damage to the inverter!
Read User Manual Online (PDF format)
Loading......