KOHLER K-22860IN Universal PureClean Bidet Instruction Manual

Table of Contents

Please read these instructions carefully to familiarize yourself with the required tools, materials, and installation sequences. Follow the sections that pertain to your particular installation. This will help you avoid costly mistakes. In addition to proper installation, read all operating and safety instructions.
All information in these instructions is based upon the latest product information available at the time of publication. Kohler India reserves the right to make changes in product characteristics, packaging or availability at any time without notice.
These instructions contain important care, cleaning, and warranty information – please leave instructions for the consumer.
In case product is damaged when unpacked for ﬁrst time, please do not install the product and report to customer care immediately. TOOLS & MATERIALS REQUIRED (Not supplied)

NOTES

KOHLER-K-22860IN-Universal-PureClean-Bidet-fig1

KOHLER-K-22860IN-Universal-PureClean-Bidet-fig2

Notice:

Fixture dimensions are nominal and conform to tolerances according to ASME Standard A112. 19.2M.
Product illustrations shown are representative only, actual products may vary.
Kohler Co. reserves the right to make changes in product characteristics, packaging, or availability at any time without notice.

PREPARATION
- Turn the water supply off.
- Install or relocate the supply tubing and waste pipe as necessary to conform to the rough-in dimensions.
- Install the shut-off valve.
- Install bowl, seat and aka health faucet.
  CAUTION:
  Do not under size waste piping as it will lead to clogging of the outlet and reduction in rate of waste outﬂow.

INSTALLATION INSTRUCTIONS

Remove the seat from bowl.
Carefully place the universal pureclean onto bowl. Align the mounting holes of universal pureclean and bowl. Rotate mounting disc of universal purclean to align holes of bowl, if needed.
Install seat back onto the bowl.
- a. Fix bolts in hinges of seat. Insert bolts into aligned holes of bowl and universal pureclean.
- b. Tighten nut with help of tightening tool.
Turn off water supply. Remove hose of health faucet from water supply.
.
- a. Connect nut side of T-connector to water supply valve. Re-connect hose of health faucet to one side of T-connector and other side to hose of universal pureclean.
- b. Remove inlet cover from universal pureclean.
- c. Connect other end of hose to the inlet of the universal pureclean.
  CAUTION :
  Make sure that the ﬁlter does not fall from universal pureclean when removing the inlet cover.
Turn on water supply valve and check for any leakage. Tighten connections, if needed.
Rotate handle of universal pureclean by a quarter-turn (90°) to each side and check smooth functioning of each wand.
- a. Rotate clockwise for rear wash.
- b. Rotate anti-clockwise for front wash.

Do not stand, knock, or stack heavy objects on the universal pureclean. The load could damage it.
Clean the outside surface of your toilet seat with mild soap and warm water. Wipe the surface completely dry with a clean soft cloth.
Do not use any abrasive cleaners as they will scratch and dull the surface. Avoid any detergents, disinfectants, or cleaning products.
Avoid contact with abrasive chemicals and solvents such as nail polish removers, thinners, and aftershave lotions as they may damage the surface of your toilet seat.
To prevent any possible damage to the seat & its components, do not use strong acidic or strong alkaline cleaners. If the surface becomes excessively dirty, please use a mild general-purpose cleaner.
During closure, allow the seat to drop down at itss own pace. Do not force the closure as it may damage the dampers.
Avoid direct exposure to strong lights such as sunlight, ultraviolet lamps, etc.