PHILIPS dynalite DDRC420FR Relay Controller Instruction Manual
- June 4, 2024
- Philips
Table of Contents
PHILIPS dynalite DDRC420FR Relay Controller
Installation Instructions
Devices must be installed in an approved enclosure by a qualified electrician
in accordance with all national and local electrical and construction codes
and regulations.
1
/ 3 CH-CH ≤ 300 V (UL) / 400 V (CE)
Installation example
3
CH-CH = 277 / 480 V
Output Ratings/Channel (CH)
Output Ratings/Group
CH-CH ≤ 300 V (UL) / 400 V (CE) DDRC420FR ≤ 64 A (UL), 80 A (CE)
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV
technician for help. Any modifications not approved by the manufacturer of
this device could void the user’s authority to operate this device.
This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la
norme NMB-003 du Canada: CAN ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities for the communication wires specified in IEC 60364-5-52 shall not
be exceeded.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>