IQ Card-345 Touchscreen Wireless Alarm System User Guide
- June 15, 2024
- IQ
Table of Contents
IQ Card-345 Touchscreen Wireless Alarm System User Guide
QUICK GUIDE
The IQ Card-345 can be installed in to “Slot 3” of your IQ Panel 4, IQ4 Hub or
IQ4 NS to enable support of approved legacy 345 MHz SRF sensors. Swipe down
and touch “Settings” then
“Advanced Settings”. Enter your code and touch “POWER DOWN”.
Once the IQ Panel has completely powered down, unplug or disconnect the power
by removing the barrel jack connector inside the panel or by unplugging the
power supply.
NOTE: it is NOT required to disconnect the battery. BEFORE YOU BEGIN
From the bottom of the panel, find the retaining screw, loosen completely.
Once the screw has been loosened, pull the backplate away from the panel to
remove.
INSTALLING THE CARD Locate “SLOT 3” which is designated as the slot for SRF
daughter cards. Product Name: IQ Card-345 Part Number: QC005-840 Document last
updated on: 8/30/23
Swipe down and touch “Settings” then“Advanced Settings”. Enter your code and touch “POWER DOWN”
Once the IQ Panel has completely powered down, unplug or disconnect the power
by removing the barrel jack connector inside the panel or by unplugging the
power supply.
NOTE: it is NOT required to disconnect the battery
INSTALLING THE CARD
From the bottom of the panel, find the retaining screw, loosen completely.
Once the screw has been loosened, pull the backplate away from the panel to remove.
Locate “SLOT 3” which is designated as the slot for SRF daughter cards.
Match the pins on the bottom of the IQ Card to the terminal on the IQ Panel.
Push the IQ Card firmly into place
Install and tighten the provided locking screw to secure the IQ Card into
place.
Ensure the antenna remains connected and does not interfere with the battery
Replace the back cover, top tabs first.
Ensure the white SRF antenna is routed out the hole in the backplate. Press down on the bottom and tighten the retaining screw.
Plug the power supply back in and press and hold the power button for 3 sec to power on
Swipe down and touch “Settings” the“Advanced Settings”. Enter your code and touch “System Tests”.
Touch “Daughter Cards Test”
Run the “SRF” test. Allow up to 2 min for the panel to successfully test the radio in the new IQ Card. If test fails, reboot the panel and try again.
The IQ Panel will automatically recognize the newly-installed IQ Card-345 and it is now ready to use.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>