On-Stage BC1000 Bluetooth Converter User Manual
- June 4, 2024
- On-Stage
Table of Contents
On-Stage BC1000 Bluetooth Converter User Manual
Introduction
The On-Stage BC1000 is a Bluetooth converter with a 4.0 chip. This chip offers high quality sound, and optimizes the compatibility and integral performance. Use a 3-pin XLR to connect to a console or active speaker, then use Bluetooth the connect PC, smart phone, etc for wireless transmission. When the BC1000 is low on battery, the red light will turn on.
Features
- Plug and play
- Applies to short distance transmission
- Light weight and space saving
- 3.7V lithium battery power supply
Introduction
- XLR: Unbalanced output connector.
- ON/OFF: When connecting, red and green blinking; ready to connect. Solid green: connected. Blinking red: Ran out of battery. In Use: Full charge: green light, Out of battery: red light.
- USB CHARGE: Use USB port to charge the device.
Connecting BC1000
Send the signal to BC 1000
Specifications
- Versions: Bluetooth V4.0
- Power Supply: 3.7V lithium battery power supply
- Standby current: <0.5mA
- Wireless transmission range: 10m
- Sensitivity: -80dBm ±0.1% BER
- Charging method: USB charging
- Signal to noise: ≥75dB
- Distortion: ≤ 0.1%
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Extreme Temperature: -40~80℃.
*The product shall only be connected to a USB interface of version USB3.0
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Contact the Customer Service Department
Questions or Concerns?
at cs@MusicPeopleinc.com or call us at 800-289-8889.
WARNING: Do not use with Phantom Power to avoid damage to your BC1000.
©2017 The Music People On-Stage.com
Manufacturer: NINGBO ALCTRON ELECTRONICS TECHNOLOGY CO., LTD.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>