FINE FIXTURES SE30 Serenity Vanity Collection Instruction Manual
- June 15, 2024
- FINE FIXTURES
Table of Contents
FINE FIXTURES SE30 Serenity Vanity Collection
SAFETY PRECAUTION
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
2 PEOPLE ARE REQUIRED TO LIFT AND DURING I ENTIRE INSTALLATION OF THIS PRODUCT
INSTALLATION OF THIS PRODUCTS BY AN INEXPERIENCED INSTALLER MAY RESULT PERSONAL INJURY OR DEATH!
We reserves the right to change, update, modify, alter, redesign this
manual/product or its policies without prior notice!
It is your responsibility to visit website to download or contact customer
service for the most updated version of the installation instructions.
We shall not be liable for any injuries or property damages in connection with
this product during installation or use of this product!
- LIMITED WARRANTY IS VOID ON ANY COMMERCIAL INSTALLATION.
- WE ARE NOT RESPONSIBLE FOR LOCAL CODE COMPLIANCE FOR THIS PRODUCT.
- BUILDING AND PLUMBING CODES MAY VARY FROM STATE-TO-STATE IN ACCORDANCE TO YOUR LOCATION.
- WE ARE NOT RESPONSIBLE FOR PROVIDING ANY COMPLIANCE CERTIFICATIONS.
- WE ARE NOT RESPONSIBLE TO PROVIDE ANY TYPE OF CERTIFICATIONS FOR THIS PRODUCT.
- UNDER NO CIRCUMSTANCES WE SHALL NOT BE LIABLE FOR ANY AND ALL INCIDENTAL DAMAGES SUSTAINED IN CONNECTION WITH THIS PRODUCT NEITHER MANUFACTURE, NOR DISTRIBUTOR, NOR RETAILER IS RESPONSIBLE FOR WATER DAMAGE OR FLOOD CAUSED DUE TO USE OF THIS PRODUCT.
- UNDER NO CIRCUMSTANCES WE SHALL NOT BE LIABLE FOR ANY AND ALL FEES, COST OF INSTALLATION/REINSTALLATION/REMOVAL, SUBSEQUENT DAMAGE OR TRANSPORTATION IN CASE OF THE PRODUCT DEFECT.
VANITY COMPONENTS
DURING UNPACKING THE PRODUCT AND PRIOR TO INSTALLATION INSPECT YOUR NEW
PRODUCT FOR ANY DAMAGES OR MISSING PARTS.
DO NOT ATTEMPT TO INSTALL OR OPERATE THE PRODUCT IF THE PRODUCT IS DAMAGED.
NO.
|
Draw
| QTY
---|---|---
Part A
| |
2
Pieces
Part B
| |
2
Pieces
Part C
| |
2
Pieces
Part D
| Length=115mm(4 1/2”)|
1
Pieces
Part E
| Length=139mm(5 1/2”)|
1
Pieces
Part F
| Handle screws(M4*18mm|
4
Pieces
Part G
| *Screws(M412mm)**|
4
Pieces
Part H
| Screws(M6*18mm)|
8
Pieces
Part I
|
I Screws(M6*8mm)
|
8
Pieces
Part J
| Bracket(40X20X20mm)|
4
Pieces
Part K
| |
2
Pieces
TOOLS REQUIRED
-
Silicone
-
Safety Glass
-
Level
-
Silicone/ Caulk Gun
-
Tape Measure
-
Hammer
-
Knife
-
Pencil/Marker
-
Philips Screwdrive
-
Soft Cloth or Blanket
-
Drill
-
Drill Bit
DIMENSIONS/TECHNICAL DATA
MODEL# SE30
STEP #1
STEP #2
STEP #3
STEP #4
STEP #5
STEP #6
STEP #7
DONE
Customer Support
R ETAIN THIS INSTALLATION MANUAL FOR FUTURE REFERENCE.
Thank you for choosing FINE FIXTURES.
206 Wembly Road
New Windsor, NY 12553
Phone: 718.602.6060
Fax: 718.963.2082
info@finefixtures.com
www.finefixtures.com
Documents / Resources
| FINE
FIXTURES SE30 Serenity Vanity
Collection
[pdf] Instruction Manual
SE30 Serenity Vanity Collection, SE30, Serenity Vanity Collection, Vanity
Collection, Collection
---|---