Fine Fixtures MOTB10W 10 Inch Rough in Round Dual Flush High Efficiency Toilet Instruction Manual
- June 9, 2024
- FINE FIXTURES
Table of Contents
Fine Fixtures MOTB10W 10 Inch Rough in Round Dual Flush High Efficiency
Toilet
INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
We reserves the right to change, update, modify, alter, redesign this
manual/product or its policies without prior notice!
It is your responsibility to visit the website to download or contact customer
service for the most updated version of the installation instructions.
We shall not be liable for any injuries or property damages in connection with
this product during installation or use of this product!
- Limited warranty is void on any commercial installation.
- We are not responsible for local code compliance for this product.
- Building and plumbing codes may vary from state-to-state in accordance to your location.
- We are not responsible for providing any compliance certifications.
- We are not responsible to provide any type of certifications for this product.
- Under no circumstances we shall not be liable for any and all incidental damages sustained in connection with this product Neither manufacture, nor distributor, nor retailer is responsible for water damage or flood caused due to use of this product.
- Under no circumstances We shal not be liable for any and all fees, cost of installation/re-installation/removal, subsequent damage or transportation in case of the product defect.
TOILET SEAT & HARDWARE
INSTALLATION
PREPARATION
Separate the cover cap from the hinge.
ASSEMBLE HINGES
INSTALL HINGES
Insert hinges with blind hole screwfixings attached into holes on toilet bowl
.
ATTACH & ADJUST SEAT
Align seat to the hinges, then light tighten the hinges.
Attach seat to the secure hinges.
ALIGN SEAT TO TOILET
Adjust seat to align to the bowl.
TIGHTEN HINGES
Tighten hinges with a screwdriver after alignment
COVER HINGES
Place the covers onto the hinges.
TOILET SEAT USAGE
To remove, push middle button until you hear a “click”, then pull straight up.
To re-install, align hinge posts with reference marks on seat, then push down
until your hear a “click”.
Two Button seat type
One Button seat type
206 WEMBLY ROAD – NEW WINDSOR, NY 12553
P: 718.602.6060
F: 718.963.2082 –
E: INFO@FINEFIXTURES.COM
TOLL FREE: 1.877.8FIXTURES
FINEFIXTURES.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>