Ampeak 2000W Pure Sine Wave Power Inverter Instruction Manual

Ampeak 2000W Pure Sine Wave Power Inverter

Specifications

• Battery Input: 12-Volt DC
• Inverter Output: 115-Volt AC

Product Information

The 2000 Watts Pure Sine Wave Safe Power Inverter is designed to convert 12-Volt DC power from your battery into 115-Volt AC power. It features three AC outlets, dual USB ports, and one cigarette lighter port, allowing you to power multiple devices simultaneously. The inverter also has an LCD display for easy monitoring of battery status, output frequency, and other important information. It comes with a power switch for easy control and a remote control port for convenience (remote control sold separately).

Product Usage Instructions

Easy Operation Steps

1. Make sure the inverter power switch is OFF.
2. Connect the red positive (+) ring terminal cable to the red positive (+) terminals of the battery and inverter.
3. Connect the black negative (-) ring terminal cable to the black negative (-) terminals of the battery and inverter.
4. Turn on the inverter power switch and plug in your appliance.

Make sure to turn off the inverter when not in use.

Open the Terminal Covers Method

1. Turn the plastic screw counter-clockwise with your finger or wrench.
2. Remove the plastic screws.
3. Remove the plastic cover and start wiring.

Troubleshooting

battery
The inverter did not turn on| Loose cable connection| Check the connection and tighten as required
Overload, over current, short circuit, over heat, overcool,
commwarn| VCCLOW VOLTAGE DC OVERLOAD DC OVER CURRENT| Restart Inverter Cool down inverter Put inverter in working
temperature Restart Inverter
Water entered the unit| AC product power consumption is higher| Disconnect the inverter and wipe immediately
Reduce loads, decrease wattages
Battery is old or defective| Battery is not being properly charged| Replace the battery
Turn on the inverter
Check the connection and tighten as required
Charge the battery Replace 12V battery
Reduce loads, decrease wattages

Questions & Answers

1. Can I use the inverter with a 24V system? No, This model can only work with a 12V battery system.

2. Can I use this inverter to charge my batteries?
   No, The Ampeak 12V DC to 120V AC inverter can only convert DC power to AC power.

3. How do I hook up the Inverter? What size cable should I use, and is it included?
   When connecting the inverter to the battery, always use the thickest wire available, in the shortest length practical. A pair of 4AWG 3ft cables with battery terminals is included in the package.

4. Will this inverter work on a 1200 watt coffee maker?
   Yes. Inverters will be rated by a wattage value, how many watts it can run at one time, would require an inverter with a higher wattage than 1200W. Ampeak Pure Sine Wave 2000W and 3000W inverter will meet your power needs.

2000 Watts

Pure Sine Wave Safe Power Inverter

12-Volt DC to 115-Volt AC with Three AC Outlets,Dual USB Ports, One Cigarette Lighter

OVERVIEW

What Is Included?

Easy Operation Steps

1. Make sure the inverter power switch is OFF.
2. Connect the red positive (+) ring terminal cable to the red positive (+) terminals of the battery and inverter.
3. Connect the black negative (-) ring terminal cable to the black negative (-)terminals of the battery and inverter.
4. Turn on the inverter power switch and plug in your appliance.

Make sure the inverter is turned OFF when not in use.

Open the terminal covers method

1. Turn the plastic screw counter-clockwise with your finger or wrench.
2. Remove the plastic screws.
3. Remove the plastic cover and start wiring.

Specifications

Battery Input:

Inverter Output:

8

| Inverter Overheat Protection: Internal Electronic Components of Inverter Temperature > 105°C/221°F
9| USB Output Voltage: 5V
10| USB Output Current: Dual 3.1A
11| Operating Temperature: -10°C/14°F ~ 40°C/104°F
12| Advice Storage Temperature: -20°C/-4°F~65°C/149°F

Troubleshooting

Questions & Answers

Can I use the inverter with a 24V system?

No, This model can only work with a 12V battery system.

Can I use this inverter to charge my batteries?

No, The Ampeak 12V DC to 120V AC inverter can only convert DC power to AC power.

How do I hook up the Inverter? What size cable should I use, and is it included?

When connecting the inverter to the battery always use the thickest wire available, in the shortest length practical. A pair of 4AWG 3ft cables with battery terminals is included in the package.

Will this inverter work on a 1200 watt coffee maker?

Yes. Inverters will be rated by a wattage value, how many watts it can run at one time, would require an inverter with a higher wattage than 1200W. Ampeak Pure Sine Wave 2000W and 3000W inverter will meet your power needs.

Can this inverter work with lithium batteries?

Yes, as long as the lithium battery is rated for 12V applications.

Does the inverter come with remote?

No, the inverter remote is sold separately, you can search Ampeak inverter remote.

Does this inverter have shutdown feature?

No, it does not have.

Safe Protections

Limited Warranty

18-Month Limited Warranty Policy
18-Month Limited Warranty Policy is the only one that applies to this unit, and it sets forth all the responsibilities of Ampeak. There is no other warranty, other than those describedherein. Any implied warranty of merchant ability or fitness for a particular purpose on this unit is limited in duration to the duration of this warranty. This unit is warranted to the original purchaser only to be free of defects in materials and workmanship for 18-month from the date of purchase without additional charge. The warranty does not extend to subsequent purchasers or users.

Ampeak will not be responsible for any amount of damage in excess of the retail purchase price of the unit under any circumstances. Incidental and consequential damages are specifically excluded from coverage under this warranty. This unit is not intended for commercial use. This warranty does not apply to damage to units from misuse or incorrect installation/connection. Misuse includes wiring or connecting to improper polarity power sources.

Return/Repair Policy
If you are experiencing any problems with your unit, please contact Ampeak Customer Service Department at: [email protected] returning the product to Amazon.
After speaking to a customer service representative, if products are deemed non-working or malfunctioning, the product may be returned to amazon within 30 days of original purchase. Any defective unit that is returned to Amazon within 30 days of the date of purchase will be replaced free of charge or fully refunded at the buyer’s option.
If such a unit is returned more than 30 days but less than 18-month from the purchase date,the manufacturer will repair the unit or at its option, replace it, free of charge. If the unit is repaired, new or reconditioned replacement parts may be used, at the manufacturer’s option. A unit may be replaced with a new or reconditioned unit of the same or comparable design. The repaired or replaced unit will then be warranted under the terms of the remainder of the warranty period.

Limitations
This warranty does not cover accessories, such as adapters and batteries, damage or defects resulting from normal wear and tear(including chips, scratches, abrasions, discoloration, or fading due to usage or exposure to sunlight), accidents, damage during shipping to our service facility, alterations, unauthorized use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance, fire and flood.

Important Safety Information

Safety Statement
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact AMPEAK for replacements or an electronic edition. If the operator is not fluent in English, the product and safety instructions shall be read and discussed with the operator in the operator’s native language by the purchaser owned or his designee,making sure that the operator comprehends its contents.
READ ALL WARNINGS AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THIS PRODUCT!

Warning: Risk Of Shock, Fire, And Explosion.
The inverter produces the same potentially lethal AC power as normal household outlets.
lt is suggested that you treat it as a normal AC outlet.

Caution: Personal Safety & Equipment Damage.
Keep Away From Children, This Is Not A Toy.

• DO NOT insert foreign objects into the AC outlet, the USB port, or the ventilation hole.
• DO NOT use this product where there are flammable fumes or gases, such as in the bilge of a gasoline-powered boat, or near propane tanks.
• NEVER smoke or allow a spark or flame in the vicinity of the engine or batteries.
• Make sure the inverter wiring is of proper size and rating and in good condition.
• Operating the inverter with damaged wiring may void warranty.
• DO NOT attempt to fix the unit by disassembling or modification. You can cause self-injury and disassemble and modifying the unit will void your warranty.
• Disconnect DC power source from the inverter, before attempting to service, clean, or operate on any circuits connected to the inverter. Simply turning OFF the switch of the inverter will not disconnect the power, thereby causing electric shock.
• Never connect the inverter to any power distribution systems or branch circuits.
• DO NOT make any electrical connections or disconnections in areas designated as ignition protected. This unit is NOT approved for ignition-protected areas.
• Connect the unit to a power source with a normal output of 12v DC ONLY. 6V battery voltages are too low and 24V battery voltages are too high, which will damage the unit.
• DO NOT use the inverter in temperatures above 14°F (-10°C) – 104°F (40°C).
• DO NOT expose this product to water, rain, snow, condensation, or spray.
• DO NOT connect the unit to live AC power circuits or there will be damage to the inverter.
• DO NOT connect any AC device which has its neutral conductor connected to the ground to the unit.
• DO NOT use the inverter with medical devices since it is not approved for medical applications.
• DO NOT permanently install the unit in the engine compartment. Certain chargers for small nickel-cadmium batteries can be damaged if connected to the inverter.
• DO NOT use the inverter beyond its rated wattage capacity. Add the total watts of all connected appliances and be sure the total is less than the inverter’s capacity.

This product may contain one or more chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. Wash hands thoroughly after handling.

NOTE:
If you are unsure about using your rechargeable appliance with the inverter, contact the Ampeak: [email protected] to determine the rechargeable appliances’ compatibility with the inverter.

Help Centrel

Thank you for choosing Ampeak 2000 Watts Pure Sine Wave Safe Power Inverter. Please read this instruction carefully as they contain important information, and safety requirements. If you have trouble understanding the instructions, or have any questions regarding its operation, please contact our friendly customer support team, via customer.[email protected]

Facebook
ampeak
Official Website
www.ampeak.com
Amazon
www.amazon.com/ampeak

References

• Ampeak
• High & Low Power Inverter | Smart Battery Charger – Ampeak

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>