Ampeak 3000 Watts Pure Sine Wave Safe Power Inverter Instruction Manual

June 14, 2024
Ampeak

3000 Watts
Pure Sine Wave Safe Power Inverter
Instruction Manual

3000 Watts Pure Sine Wave Safe Power Inverter

Ampeak 3000 Watts Pure Sine Wave Safe Power
Inverter12-Volt DC to 115-Volt AC with Three AC Outlets,
Dual USB Ports, One Cigarette LighterAmpeak 3000 Watts Pure Sine Wave Safe
Power Inverter - fig1

What Is Included?

Ampeak 3000 Watts Pure Sine Wave Safe Power Inverter - in the
boxe

Easy Operation Steps

  1. Make sure the inverter power switch is OFF.Ampeak 3000 Watts Pure Sine Wave Safe Power Inverter - inverter power
  2. Connect the red positive (+) ring terminal cable to the red positive (+) terminals of the battery and inverter.Ampeak 3000 Watts Pure Sine Wave Safe Power Inverter - positive
  3. Connect the black negative (-) ring terminal cable to the black negative (-)terminals of the battery and inverter.Ampeak 3000 Watts Pure Sine Wave Safe Power Inverter - terminal cable
  4. Turn on the inverter power switch and plug in your appliance.Ampeak 3000 Watts Pure Sine Wave Safe Power Inverter - power switch

Make sure the inverter is turned OFF when not in use.

Open the terminal covers method

| |
---|---|---
1. Turn the plastic screw counter-clockwise with your finger or wrench.| 2. Remove the plastic screws.| 3. Remove the plastic cover and start wiring.

Specifications

Battery Input:

1 Continuous Input Voltage: 12V
2 DC Voltage Input Range: DC 11V~15V
3 DC Input Low Voltage Shutdown: 9.5V±0.5V
4 DC Input Overvoltage Protection: 16V±0.5V
5 Input DC Fuse: 12*40A

Inverter Output:

1 AC Output Voltage: AC 105V~125V
2 Output Continuous Power: 3000 Watts
3 Output Overload Power: 3200 Watts
4 Output Surge Power: 6000 Watts
5 AC Output Frequency: 60±1Hz
6 Output Voltage Waveform: Pure Sine Wave
7 Full Load Efficiency: ≥90%
8 Inverter Overheat Protection: Internal Electronic Components of Inverter

Temperature > 105°C/221°F
9| USB Output Voltage: 5V
10| USB Output Current: Dual 3.1A
11| Operating Temperature: -10°C/14°F ~ 40°C/104°F
12| Advice Storage Temperature: -20°C/-4°F~65°C/149°F

Troubleshooting

Problem Cause Solution

No Power,
Led screen no indicator, Fans no run| Battery is defective| Replace the battery
The inverter did not turn on| Turn on the inverter
Loose cable connection| Check the connection and tighten as required
Alarm is sounding
(L
died screen display
protections)| BATLOW VOLTAGE| Charge the battery
BATOVER VOLTAGE| Replace 12V battery
OVERLOAD| Reduce loads, decrease
wattages OVER CURRENT
SHORT CIRCUIT| Restart Inverter
OVER HEAT| Cool down inverter
OVERCOOL| Put inverter in warkin gtemp erature
COM MWARN| Restart Inverter
VCCLOW VOLTAGE| Check the connection and tighten as required
DC OVERLOAD| Reduce loads, decrease wattages
DC OVER CURRENT
Water entered the unit| Water entered the unit| Disconnect the inverter and wipe immediately
Battery run time is less than
expected| AC product power consumption is higher| The total watts needed by the AC products should be no more than the inverter’s watt rating
Battery is old or defective| Replace the battery
Battery is not being properly charged| Some chargers are not able to fully recharge a battery, Make sure you use a powerful charger
Battery does not have enough capacity| Use a battery with a higher amp-hour rating

Questions & Answers

1. Can I use the inverter with a 24V system?

No, This model can only work with a 12V battery system.

2. Can I use this inverter to charge my batteries?

No, The Ampeak 12V DC to 120V AC inverter can only convert DC power to AC power.

3. How do I hook up the Inverter? What size cable should I use, and is it included?

When connecting the inverter to the battery always use the thickest wire available, in the shortest length practical. A pair of 4AWG 3ft cables with battery terminals is included in the package.

4. Will this inverter work on a 1800 watt coffee maker?

Yes. Inverters will be rated by a wattage value, how many watts it can run at one time, would require an inverter with a higher wattage than 1200W. Ampeak Pure Sine Wave 2000W and 3000W inverter will meet your power needs.

5. Can this inverter work with lithium batteries?

Yes, as long as the lithium battery is rated for 12V applications.

6. Does the inverter come with remote?

No, the inverter remote is sold separately, you can search Ampeak inverter remote.

7. Does this inverter have shutdown feature?

No, it does not have.

Safe Protections

Screen Display| Protection Name|

Audible Alarm

---|---|---
1| Battery Low Voltage
Protection| Input Voltage: 9.5V ± 0.5V
Inverter Stops Working
Screen Display BATLOW VOLTAGE
Continuous Alarm for 60 Seconds
DC Cigarette
Lighter Low Voltage
Protection| DC Output Voltage: 9.5V ± 0.5V Inverter Stops Working
Screen Display BATLOW VOLTAGE
Continuous Alarm for 60 Seconds
2| Battery Over Voltage
Protection| Input Voltage: 16V ± 0.5V
Inverter Stops Working
Screen Display BATOVER VOLTAGE Continuous Alarm for 60 Seconds
DC Cigarette
Lighter Over Voltage
Protection| DC Output Voltage: 16V ± 0.5V Inverter Stops Working
Screen Display BATOVER VOLTAGE Continuous Alarm for 60 Seconds
3| Output Overload
Protection| Output Wattage >3200W
Inverter Stops Working
Screen Display OVERLOAD Continuous Alarm for 60 Seconds Allow Two Restores, Program locked Permanently in the Third Time
4| Output Over Current
Protection| Output Electric Current >35 Amps Inverter Stops Working
Screen Display OVER CURRENT Continuous Alarm for 60 Seconds
5| Output Short Circuit
Protection| Inverter Stops Working
Screen Display SHORT CIRCUIT Continuous Alarm for 60 Seconds
6| Inverter Overheat
Protection| Internal Electronic Components of
Inverter Temperature >105°C(221°F) Inverter Stops Working
Screen Display OVERHEAT
Continuous Alarm for 60 Seconds
7| Inverter Overcool
Protection| Internal Electronic Components of Inverter Temperature < -10°C(14°F) Inverter Stops Working
Screen Display OVERCOOL Continuous Alarm for 60 Seconds
8| Communication Error Protection| Communication Error
Inverter Stops Working
Screen Display COM MWARN Intermittent Alarm for 30 Seconds
9| VCC Power Down
Protection| Inverter Power Down
Inverter Stops Working
Screen Display VCCLOW VOLTAGE Intermittent Alarm for 30 Seconds
10| Inverter Low Voltage
Protection| Output Voltage (80V
Inverter Stops Working
Screen Display INVLOW VOLTAGE Continuous Alarm for 60 Seconds
11| Inverter Over Voltage
Protection| Output Voltage ?-.140V
Inverter Stops Working
Screen Display INVOVER VOLTAGE
Continuous Alarm for 60 Seconds
12| DC Cigarette
Lighter Overload Protection| DC Output Wattage >400W
Inverter Stops Working
Screen Display DC OVERLOAD
The Outlets Stop Working
Continuous Alarm for 60 Seconds Allow Two Restores, Program locked Permanently in the Third Time
13| DC Cigarette
Lighter Over Current Protection| DC Output Electric Current >35 Amps Inverter Stops Working
Screen Display DC OVER CURRENT Continuous Alarm for 60 Seconds
14 No Display| USB Short Circuit Protection| No Alarm Remind
USB Ports Stop Working
15 No Display| Isolated Circuit| Input Circuit and Output
Circuit are Isolated
The Two Circuits are Insulated from Each Other to Ensure Circuit Safety
16 No Display| Intelligent Temperature Control| Built Cooling Silent Fans Start Working When The Temperature is Over 113 °F
17 No Display| Built-in Heat Dissipation| Improve The Performance and Life of Internal Components
Keep The Inverter at Safe Temperature

Limited Warranty

18-Month Limited Warranty Policy
18-Month Limited Warranty Policy is the only one that applies to this unit, and it sets forth all the responsibilities of Ampeak. There is no other warranty, other than those described herein. Any implied warranty of merchant ability or fitness for a particular purpose on this unit is limited in duration to the duration of this warranty. This unit is warranted to the original purchaser only to be free of defects in materials and workmanship for 18-month from the date of purchase without additional charge. The warranty does not extend to subsequent purchasers or users. Ampeak will not be responsible for any amount of damage in excess of the retail purchase price of the unit under any circumstances. Incidental and consequential damages are specifically excluded from coverage under this warranty. This unit is not intended for commercial use. This warranty does not apply to damage to units from misuse or incorrect installation/connection. Misuse includes wiring or connecting to improper polarity power sources.
Return/Repair Policy
If you are experiencing any problems with your unit, please contact Ampeak Customer Service Department at: customer. services@ampeak.com returning the product to Amazon. After speaking to a customer service representative, if products are deemed non-working or malfunctioning, the product may be returned to amazon within 30 days of original purchase. Any defective unit that is returned to Amazon within 30 days of the date of purchase will be replaced free of charge or fully refunded at the buyer’s option.
If such a unit is returned more than 30 days but less than 18-month from the purchase date, the manufacturer will repair the unit or at its option, replace it, free of charge. If the unit is repaired, new or reconditioned replacement parts may be used, at the manufacturer’s option. A unit may be replaced with a new or reconditioned unit of the same or comparable design. The repaired or replaced unit will then be warranted under the terms of the remainder of the warranty period.
Limitations
This warranty does not cover accessories, such as adapters and batteries, damage or defects resulting from normal wear and tear(including chips, scratches, abrasions, discoloration, or fading due to usage or exposure to sunlight), accidents, damage during shipping to our service facility, alterations, unauthorized use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance, fire and flood.
Important Safety Information
Safety Statement
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact AMPEAK for replacements or an electronic edition. If the operator is not fluent in English, the product and safety instructions shall be read and discussed with the operator in the operator’s native language by the purchaser owned or his designee, making sure that the operator comprehends its contents.
READ ALL WARNINGS AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THIS PRODUCT!
Warning: Risk Of Shock, Fire, And Explosion.
The inverter produces the same potentially lethal AC power as normal household outlets.
lt is suggested that you treat it as a normal AC outlet.

  • DO NOT insert foreign objects into the AC outlet, the USB port, or the ventilation hole.

  • DO NOT use this product where there are flammable fumes or gases, such as in the bilge of a gasoline-powered boat, or near propane tanks.

  • NEVER smoke or allow a spark or flame in the vicinity of the engine or batteries.

  • Make sure the inverter wiring is of proper size and rating and in good condition.
    Operating the inverter with damaged wiring may void warranty.
    Caution: Personal Safety & Equipment Damage. Keep Away From Children, This Is Not A Toy.

  • DO NOT attempt to fix the unit by disassembling or modification. You can cause self-injury and disassemble and modifying the unit will void your warranty.

  • Disconnect DC power source from the inverter, before attempting to service, clean, or operate on any circuits connected to the inverter. Simply turning OFF the switch of the inverter will not disconnect the power, thereby causing electric shock.

  • Never connect the inverter to any power distribution systems or branch circuits.

  • DO NOT make any electrical connections or disconnections in areas designated as ignition protected. This unit is NOT approved for ignition-protected areas.

  • Connect the unit to a power source with a normal output of 12v DC ONLY. 6V battery voltages are too low and 24V battery voltages are too high, which will damage the unit.

  • DO NOT use the inverter in temperatures above 14°F (-10°C) – 104°F (40°C).

  • DO NOT expose this product to water, rain, snow, condensation, or spray.

  • DO NOT connect the unit to live AC power circuits or there will be damage to the inverter.

  • DO NOT connect any AC device which has its neutral conductor connected to the ground to the unit.

  • DO NOT use the inverter with medical devices since it is not approved for medical applications.

  • DO NOT permanently install the unit in the engine compartment. Certain chargers for small nickel-cadmium batteries can be damaged if connected to the inverter.

  • DO NOT use the inverter beyond its rated wattage capacity. Add the total watts of all connected appliances and be sure the total is less than the inverter’s capacity.

This product may contain one or more chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. Wash hands thoroughly after handling.
NOTE:
If you are unsure about using your rechargeable appliance with the inverter, contact the Ampeak: customer. services@ampeak.com to determine the rechargeable appliances’ compatibility with the inverter.

Help Centrel

Thank you for choosing Ampeak 3000 Watts Pure Sine Wave Safe Power Inverter. Please read this instruction carefully as they contain important information, and safety requirements. If you have trouble understanding the instructions, or have any questions regarding its operation, please contact our friendly customer support team, via customer. services@ampeak.com

http://pic.sopili.net/l/facebook/page/1098654103

Facebook ampeak
Official Websitewww.ampeak.com
Amazonwww.amazon.com/ampeak

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals