BROAN FG7T Two Stage Variable Speed Condensing Upflow User Manual

BROAN FG7T Two Stage Variable Speed Condensing Upflow

TECHNICAL SPECIFICATIONS

FG7T (E and N Series) Smartlite®
Two Stage, Variable Speed, Condensing Upflow and Downflow Gas Furnaces
Induced Draft – 96% AFUE
Input 60,000 – 115,000 Btuh

• The high efficiency upflow gas furnace may be installed free standing in a utility room, basement, or enclosed in an alcove or closet. The extended flush jacket provides a pleasing “appliance appearance.” Design certified by CSA for application in Canada and the United States.

• iSEERTM : Energy efficient brushless DC (ECM) motor can give up to 1 SEER point efficiency gain in cooling.

• 100% Fired and Tested: All units and each component are tested on the manufacturing line.

• Best Packaging in the Industry: Unique corner post design assures product will arrive to the homeowner dent free.

• 30 Second Blower Delay: At start-up assures a warm duct temperature at furnace start-up. Adjustable blower off settings (60, 90, 120 and 180 seconds).

• 30 Second Post Purge : Increases life of heat exchanger.

• Hot Surface Igniter: Innovative application of a silicon nitride type igniter. Utilizes proven Smartlite® technology.

• Color Coded Wire Harness: Designed to fit the components, all with quick-connect fittings for ease of service and replacement.

• Flexible Category IV Venting System: May be vertically or horizontally vented using either a one-pipe or two-pipe system for maximum flexibility in installation.

• High Static Blowers: All models equipped with high static ECM blowers, with 16 speeds for heating & cooling.

• Low Boy Height: Easy to apply in low ceiling applications, works well with taller high SEER coils, easier to handle and install.

• Heat Exchanger: Heavy gauge aluminized steel primary heat exchanger and stainless steel secondary heat exchanger assures a long life.

• 90 Second Fixed Cooling Cycle Blower-Off Delay (TDR): Increases cooling performance when matched with a Nortek Global HVAC coil.

• LP Convertible: Simple burner orifice and regulator spring change for ease of convertibility (as an accessory).

• Diagnostic Lights: Dedicated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes.

• nitrated Control Boards : With connections for electronic air cleaner, humidifier, and dehumidification.

• Two Piece Door Design: Enhances furnace appearance and uses captured screws to prevent losing door screws.

• Blower Compartment: Sealed door to reduce air leakage and insulated for ultra quiet operation.

• Sealed Vestibule: Reduces burner and inducer sound levels.

• Two Stage Inducer: Optimizes efficiency on first stage heat and reduces sound levels.

• Furnace Air Leakage: These furnaces comply with Energy Star cabinet air leakage requirement of less than or equal to 2%. Keep the conditioned air flowing to where it’s needed.

LOCATION OF FURNACE COMPONENTS

DOWNFLOW FURNACE (*TN SERIES)

DIMENSIONS

NOTE : Dimensions shown in inches

FG7TE 96% High Efficiency Upflow Series

FG7TN 96% High Efficiency Downflow Series

BLOWER PERFORMANCE – FG7TE/TN

1. Two openings are recommended for airflows above 1,600 CFM if the filter(s) is (are) adjacent to the furnace.
2. Temperature rises in the table are approximate. Actual temperature rises may vary.
3.  Temperature rises shaded in grey are for reference only. These conditions are not recommended.
4. Rated static is .5″ ESP in W.C.

COOLING AIRFLOW

VENTING
All models are approved for vertical non direct (1 pipe) and direct (2 pipe) venting applications. See Vent Table below for specified sizes and allowable lengths.

1. Subtract 2.5 ft. for each additional 2 inch long radius elbow, 5 ft. for each additional 2 inch short radius elbow, 3.5 ft. for each additional 3 inch long radius elbow, and 7 ft. for each additional 3 inch short radius elbow. Subtract 5ft for each 2” tee and 8ft for each 3” tee.
2. Two 45 degree elbows are equivalent to one 90 degree elbow.
3.  This table applies for elevations from sea level to 2,000 ft. For higher elevations, decrease pipe lengths by 8% per 1,000 ft of altitude.

MODEL IDENTIFICATION CODE

SPECIFICATIONS

Note :
All models are 115V, 60 Hz. Gas Connections are 1/2″ N.P.T. AFUE = Annual Fuel Utilization Efficiency (a) Ratings to 2,000 ft. Over 2,000 ft. reduce 4% for each 1,000 ft. above sea level.

ACCESSORIES

GENERAL TERMS OF LIMITED WARRANTY

• Nortek Global HVAC, LLC will furnish a replacement for any part of this product which fails in normal use and service within the terms and conditions of the warranty.
• For complete details of the Limited Warranty, including applicable terms and conditions, see your local installer or contact the Nortek Global HVAC, LLC warranty department for a copy.

Before purchasing this appliance, read important energy cost and efficiency information available from your retailer. Specifications and illustrations subject to change without notice and without incurring obligations. Printed in U.S.A (06/2017)

730E-0617 (Replaces 730E-0117)
www.broanhvac.net

Broan® trademark used under license. © Nortek Global HVAC, LLC. All Rights Reserved.

References

• TCPDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>