Schneider Electric XB4FG41 Harmony Flush Mount Selector Switch User Guide
- June 15, 2024
- Schneider Electric
Table of Contents
Schneider Electric XB4FG41 Harmony Flush Mount Selector Switch User Guide
DANGER
HAZARD OF ELECTRIC SHOCK
- Install the product following the installation conditions described below.
- Hole shape and diameter, tightening torques and spacer orientation must comply with these instructions.
- The accessory ZB5AZ905 must be used to tighten the nut.
- Ground the XB4Fpp / ZB4Fpp when installed on isolating support
Electrical equipment should be installed, operated, serviced, and maintained
only by qualified personnel.
No responsibility is assumed by Schneider Electric for any consequences
arising out of the use of this material.
0,8 Nm / 7.5 lb-in (maxi 1,2 Nm / 10.6 lb-in)
For use on flat surface of a type 4, type 4X, type 12, and type 13
XB4Fpp / ZB4Fpp
X = 50 mm / 1.97 in| XB4Fpp / ZB4Fpp XB5Fpp / ZB5Fpp
X = 50 mm / 1.97 in
---|---
XB5Fpp / ZB5Fpp
X = 40 mm / 1.57 in|
mm
inch| | |
---|---|---|---
mm2 AWG| 0,22…2,5 24….14| 0,22…2,5 24….14| 0,22…1,5 24…16
For EU Declaration of Conformity see: www.schneider-electric.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>