TELTONIKA Networks RUT951 Industrial 4G LTE Router User Guide
- June 13, 2024
- TELTONIKA Networks
Table of Contents
TELTONIKA Networks RUT951 Industrial 4G LTE Router User Guide
Scan the QR code for instructions
teltonika-networks.com/QSG_RUT951
EXTEND YOUR DEVICE CAPABILITIES WITH REMOTE MANAGEMENT OPTIONS!
Scan the QR code to start your free 30-day RMS experience
teltonika-networks.com/product/rms/
TECHNICAL INFORMATION
Radio specifications
RF technologies| 2G, 3G, 4G, WiFi
Max RF Power| 33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE, 20 dBm@WiFi
**Bundled accessories specifications*
Power adapter| Input: 0.45A@100-240 VAC, Output: 9 VDC, 1A, 4-pin plug
Mobile antenna| 698-960/1710-2690 MHz, 50 0, VSWR<3, gain4 dBi,
omnidirectional, SMA male connector
WiFi antenna| 2400-2500 MHz, 500, VSWR<2.5, gain** 5dBi, omnidirectional, RP-
SMA male connector
COMPLIANCE INFORMATION*
RUT951 router must be used in compliance with any and all applicable national
and international laws and with any special restrictions regulating the
utilization
of the communication module in prescribed applications and environments,
Simplified EU and UK Declaration of Conformity
Hereby, TEL TON I KA NETWORKS declares that this RUT951 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and with Radio Equipment Regulations 2017.
The full text of the EU and UK Declaration of Conformity is available at the following internet address: wiki.teltonika-networks.com/view/Certificates
Detailed compliance information is available at the following internet address: wiki.teltonika-networks.com/view/Certificates
FCC
This device complies with part 15 of the FCC Rules. Operation Is subject to the following two conditions:
- This device may not cause harmful Interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Detailed compliance information is available at the following internet address: wiki.teltonika-networks.com/view/Certificates
IC
This radio transmitter [enter the device’s ISED certification number] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
- Order code dependent.
- Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>