8BitDo SN30 Pro Bluetooth Controller Instruction Manual
- June 15, 2024
- 8Bitdo
Table of Contents
8BitDo SN30 Pro Bluetooth Controller
SN30 Pro for Android- instruction manual
- press the Xbox button to turn on the controller.
- hold the Xbox button for 6 seconds to turn off the controller.
Android
- system required: Android 9 or above
Bluetooth Connection
- press the Xbox button to turn on the controller, status LED starts to blink.
- hold the pair button for 3 seconds to enter its pairing mode, status LED starts to blink rapidly. (This is required for the very first time only)
- go to your Android device’s Bluetooth setting, pair with [SBitDo SN30 Pro for Android], LED stays solid when connection is successful.
Wired Connection
- OTG support is required on your Android device, please contact your device manufacturer for more details. Connect the controller to the USB port of your Android device, wait till the controller is successfully recognized by your Android device to play.
Apple
- required system: iOS 16.3, iPadOS®16.3, tvOS® 16.3, mac OS® 13.2 or above. Applea, iPadosa, macosa, and MS• are trade marOS Apple Inc., registered in the U.S. and other countries.
Bluetooth Connection
- press the Xbox button to turn on the controller, status LED starts to blink.
- hold the pair button for 3 seconds to enter its pairing mode, status LED starts to blink rapidly. (This is required for the first only)
- go to your Apple device’s Bluetooth setting, pair with [8BitDo SN30 Pro for Android]. LED stays solid when the connection is successful.
Button Swap
- LED blinks continuously when the swapped button is pressed.
- the swapped buttons will not be saved after turn off the controller.
- Pad, view, menu, LT, RT and Xbox buttons are not supported. Hold either two buttons you would like to swap, then press the star button to activate/deactivate the button swap.
Battery
Built-in 480mAh Li-on battery with 16 hours of playtime, rechargeable with 1 to 2 hours of charging time.
status LED indicator-
- low battery mode: red LED blinks
- battery charging: green LED blinks
- battery charged: green LED stays solid
the controller will turn off in 2 minutes with no connection or 15 minutes of
inactivity when connected with Bluetooth
controller stays on with a USB connection.
Ultimate Software
- it gives you elite control over every piece of your controller: customize button mapping, adjust stick & trigger sensitivity. Please visit support.Bbitdo.com for the application.
- press the profile button to activate/deactivate the custom profile. The profile indicator will not light up when using the default setting.
support
- please visit support.Bbitdo.com for further information & additional support.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>