REIDEA R7 Pro Electric Lighter with Fingerprint Lock User Manual

User Manual

How To Use:

Instructions for Product Use

1. Charge
   Please charge for 30 minutes after receiving the product.
   It charges through USB interface with an outputvoltage of DC 5V+0.5V and output current below 3000mA.
   The indicator light at the bottom of the lighter will flash during charging and will remain on when the lighter is fully charged.
   It takes 3-4h for a full charge,and one full charge supports 60+ times of ignition.
   If the last indicator light flashes after you unlock the lighter, it means the battery is low. Please charge it.

2. Turn On and Off
   Once the black touch panel is triggered by your finger, the indicator light will come on, and the finger contact time of the panel exceeds one second.
   To output the arc, press the ignition button in the on position.
   After using the lighter, it will automatically turn off after 10 seconds of non-operation.

3. Enroll Fingerprint
   Note: Please ensure that your finger is clean and dry before enrolling. Any finger touch will allow unlocking during the initial setup.
   Place the finger on the reader and hold it for 5 seconds until the LED turns solid blue, then release it.
   Place the same finger on the reader repeatedly, slightly changing the angles each time.
   Every 3 times, an indicator light will turn off. Repeat the process 12 times or more until all the LED lights turn off, confirming the completion of the fingerprint enrollment.

The electric lighter has 3 fingerprint enrollment channels, each allowing enrollment of 4 fingerprint angles.
Typically, you can enroll 3 different fingers across these channels.
If you face difficulty activating the lighter, consider enrolling 12 angles of the same finger across all three
Example 1:

Example 2:

Notes:
During fingerprint entry, each fingerprint contact panel must take at least 1 second to reduce false recognition.
To improve the recognition rate for fingerprints, you should always use the same finger when entering fingerprints, and not always enter the same fingerprint parts.

Restore Factory Settings

Place the finger on the reader and hold it for 8 seconds until the LED turns on and off, then release it.
Operate the reset button to restore the factory settings when fingerprints are full or need to be replaced.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>