TOWOND 100 inch Indoor Outdoor Projection Screen Instruction Manual
- June 15, 2024
- TOWOND
Table of Contents
Projector Screen with Stand
Instruction Manual
List of Accessories
(1) Upper fixator | (5) Crossbars of holder * 6 |
---|---|
(2) Lower fixator | (6) Curtain |
(3) Tripod | 7) Rubberplug * 4 |
(4) Sandbag. | 8) Hooks * 6 |
Curtain Installation procedurees
-
AS shown in figure 1: DIVIDE THE 6 rods of holer into two groups for splicing and combination four of them from the bracket upper rod the other four constitute the bracket lower rod and then use two crossbars to hold the upper and lower parts of the curtain. Bracket Upper Rod
-
(1). As shown in the following figure :
• Loosen the top screw of the triangle bracket as figure (1).
• Unfold the triangle bracket as figure(2) and figure(3).
• And then tighten the triangle bracket top screw as figure(4).2(2).The wrong way to open the triangle bracket as figure(1), figure(2), figure(3). -
As shown in Figure2:
Loosen the Fixing screw of the triangle bracket.
Adjust the Heightor Low degree of the triangle bracket. -
As shown in Figure 3: Pass the bracket upper and bracket Iower rods through the upper and lower jacks of the curtain spectively, adfig the p%2|||on of the cdrlam so that the in is in the center for vertical suspension, forming the main body.
-
As shown in Figure 4: Mount the ufiper and lower fixtures in the middle position above and below the curtain, respectively, and then, cover the four angles of the curtain with rubber plugs.
-
Tips for wrinkle free cutain:
How to get a wrinkle free curtain You can fasten the four ends of the curatin tightly with velcro.![TOWOND 100 inch Indoor Outdoor Projection Screen
-
fig1](https://manuals.plus/wp-content/uploads/2023/12/TOWOND-100-inch- Indoor-Outdoor-Projection-Screen-fig1.png)
-
As shown in the figure 5: Hang the curtain over the holder and tighten the screws that secure the mounting device. Merge the Iogwer fixture with the holder, straighten (hegcurtam to theg appropriate FOSI(IOV\ tighten the screws from the lower fixture,
and finally place the sandbag as needed and the installation is finished. Demonstration of assembly effect of single-holder projector screen (Figure 5) -
Installation steps of wall-mounted curtain
As shown in the figure : first fix a hook on the wall hang the upper left angle of the curtain to lay the curtain flat according to the position of the crossbar hole in the upper right angle of curtain to fix the second hook. ****
-
https://www.youtube.com/watch?v=SOATKjvQS_U
Scan the QR code above for a video of the projector screen installation
Ifyou have any questions,
please feel free to contact our after-sales department
Mail:Towond2020@126.com