TOWOND 100 Inch Projector Screen and Stand Instruction Manual
- June 15, 2024
- TOWOND
Table of Contents
TOWOND 100 Inch Projector Screen and Stand
Outdoor Projector Screen 100 Inches
Specifications
- Screen Size: 100 inches
- Accessories Included:
- Upper crossbar x 3
- Tripod x 2
- Ground Nails x 6
- Storage bag x 1
- Screen x 1
- Windproof rope x 6
Product Usage Instructions
Curtain Installation Procedures
-
1. Check the attached picture: the 3 crossbars are assembled into a whole, which is used to support the upper part of the screen.
Note: The upper crossbars should be threaded onto the screen.
-
1. 1. Unfold the triangular bracket as shown in Figure 1.
Note: Make sure to loosen the screw before unfolding the bracket and tighten it afterwards.
-
1. 1. Loosen the fixing screw of the triangle bracket as shown in figure 1. Adjust the height or low degree of the triangle bracket.
- Cross bar connects the top screws of the triangle bracket as shown in Figure 1 and Figure 2. Then secure it with screws.
- Use a rope to fix the triangle bracket at the top, and then fasten it to the soil with ground nails as shown in Figure 1.
-
-
1. The magic tape on the left and right sides of the curtain is fixed to the tripod as shown in Figure 1.
-
-
-
1. For a video demonstration of the curtain installation, scan the QR code below.
-
FAQ
Question 1
- How do I contact the after-sales department?
Answer: You can reach our after-sales department by sending an email to Towond2020@126.com.
List of Accessories
- Upper crossbar x3
- Tripod x2
- Ground Nails x6
- Storage bag x1
- Screen x1
- Windproof rope x6
Curtain Installation Procedures
-
Check to see the attached picture: the 3 crossbars are assembled into a whole, which is used to support the upper part of the screen.
-
As shown in figure 1 :
Thread the screen onto the crossbar. -
As shown in the following figure :
①Loosen the top screw of the triangle bracket as figure1.
②Unfold the triangle bracket as figure2 and figure3.
③And then tighten the triangle bracket top screw as figure4. -
The wrong way to open the triangle bracket as Figure 1, figure 2, and figure 3.
-
As shown in figure1:
Loosen the fixing screw of the triangle bracket.
Adjust the height or low degree of the triangle bracket. -
As shown in figure 1 and figure 2:
The crossbar connects the top screws of the triangle bracket.
Then secure it with screws. -
As shown in figure1:
The magic tape on the left and right sides of the curtain is fixed to the tripod. -
As shown in figure 1:
Use a rope to fix it outdoors triangle bracket at the top, and then fasten it to the soil with ground nails.
- Scan the QR code below for a video of the curtain installation
If you have any questions, please feel free to contact our after-sales department: Mail: Towond2020@126.com.