VISUAL COMFORT Gaya ARN 2435 Medium Sconce Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT Gaya ARN 2435 Medium Sconce Instruction Manual
ASSEMBLY INSTRUCTIONS
Gaya Medium Sconce
Item # ARN 2435
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver Scissors
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from fixture (F) by removing screw (D) using provided screwdriver (E).
-
Install mounting plate (B) to the junction box and secure with mounting screws (C).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect the fixture hot wire (black) to the supply hot wire (usually black) using the wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture (F) to mounting plate (B) and secure with screw (D).
-
Remove socket ring (I) from socket (G).
ASSEMBLY INSTRUCTIONS
Gaya Medium Sconce
Item # ARN 2435
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
10. Remove shade (H) from packaging, then install to socket (G) and secure
with socket ring (I).
NOTE: If shade has additional packaging, carefully cut off from interior of
shade to avoid damages.
11. Install light bulb into the socket.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not
use abrasive or chemical agents.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>