EMITEVER KVP-TDL Triac Dimmable Driver Instruction Manual
- June 15, 2024
- EMITEVER
Table of Contents
EMITEVER KVP-TDL Triac Dimmable Driver
READ BEFORE INSTALLATION RISK OF SHOCK
BEFORE INSTALLATION
- If direct wiring to a 120-volt circuit with an ac dimmer turn off power at the circuit breaker before installing.
- Always connect (+)to positive and(-) to negative. Make sure positive never touch negative while powered.
- Allow ventilation, do not install in an airtight compartment. Cooler surrounding air temperatures extend driver life.
- Operate only within temperature range of 4 ° F (-20° C) to 104 ° F(40° C).
- Wiring must be by national & local electrical codes – low-voltage Class 2 circuit.
- Mount the driver flat to the surface to provide heat transfer for better cooling.
- It is normal for drivers to feel warm to the touch, especially when under a full-wattage load.
- For wire runs inside walls, use certified CL2 or better cabling and appropriate mounting hardware.
- Never connect 2 LED drivers to a single run of LED strips.
- The total wattage of LED fixtures connected to the driver must not exceed the wattage rating of this unit.
If you don’t know the wattage rating of your lighting, ask the manufacturer of your lighting.
LED Dimmable Driver
- Available for: 24V 25W SOW 60W
Wiring Diagram
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>