EMITEVER E0524V-272-2530-U UL LED Strip Lights User Guide
- June 15, 2024
- EMITEVER
Table of Contents
**EMITEVER E0524V-272-2530-U UL LED Strip Lights
**
SAFETY & WARNINGS
- Install in accordance with the national and local electrical code regulations.
- This product is intended to be installed and serviced by a qualified, licensed electrician.
- Only install with a Class 2 DC Constant Voltage LED driver. This product has not been evaluated for use when connected to an LED driver that does not comply with Class 2 voltage and energy limited supplies.
- Only use copper wiring. Use wires rated for at least 176 °F （80 °C） and certified for use with external connection of electrical equipment.
- Inadequate wire installation could overheat wires, and cause a fire, install applicable wire between driver, fixture, and any controls in between. When choosing wire, factor in voltage drop, amperage rating, and type (in-wall rated, wet location rated, ect.) .
OTHERS
Energy grade: A+
Warranty: 5years
Working hour: 50,000hrs lifetime for Tc<158°F
Working temperature: -4°F~+113°F
Working humidity: 40%-70%RH
Measurement: L5000
Static Electricity: 2000V(ESD)
WIRING DIAGRAM APPLICATION
-
Measure the LED light strip to your desired length, and locate the nearest cut line.
-
Using your scissors, cut neatly along the cut line. (Steps A pertain to dry location applications. Steps B-C pertain to wet location strip installations.)
A. Cut the tape at the line indicated with the scissors icon.
B. All cut points must be sealed with silicone adhesive (not included), and wet location end caps.
C. Mount with included mounting clips and screws. Silicone adhesive can also be utilized to mount tape to surfaces.
-
Clean surface where you intend to install the Emitever LED Strips.
-
Remove the backing from the light strip to reveal adhesive tape.
-
Press down and run the strip in a straight line onto the surface.
-
Use mounting clips if needed to make power source wire and strips stable.
TROUBLESHOOTING
Lights not turning on?
Confirm the strip is connected to the power source.(Emitever LED strips
require a 24V DC power source.) If the lights are connected to a controller,
ensure they are switched on.
Lights not lighting up?
Check the voltage on your power source. Anything below the required voltage
(24V DC) may result in no lighting up.
Adhesive tape not sticking?
Make sure to clean your mounting surface. Mounting tape may not work on
certain surfaces such as wood, stone and other rough materials. Try Emitever
Foam Tape, Mounting Clips, or an adhesive suited to the material in question.
WARNING!
DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!
Real all warnings and installation instructions thoroughly.
HANDLE LED TAPE LIGHT WITH CARE!
DO NOT BEND LED STRIP LIGHT TO A DIAMETER LESS THAN 1.5 INCHES
DO NOT FOLD, CREASE, OR TWIST LED STRIP LIGHT
DO NOT BEND LED STRIP LIGHT ON A HORIZONTAL PLANE.
DO NOT PUT EXCESSIVE PRESSURE ON SURFACE OF TAPE LIGHT (GLASS/ACRYLIC PANES, ETC.)
DO NOT COVER STRIP LIGHT WITH ANY MATERIALS.
DO NOT POWER STRIP LIGHT WHILE ATTACHED TO SPOOL OR TIGHTLY COILED.
Thanks for choosing Emitever!
JA8 HIGH EFFICACY LED LIGHT SOURCE REQUIREMENTS
Comply with Title 24
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>