ANKER A1229 Power Core Slim User Manual

ANKER A1229 Power Core Slim

Charge Your Phone or Tablet

Charge Your Bluetooth Earphones or Smart Watches

1. Enter “trickle-charging” mode: Press the power button twice or press and hold for 2 seconds. The LED indicator will turn green.
2. Charge your devices recommended for smart watches or Bluetooth earphones.
3. Exit “trickle-charging” mode: Press the power button once again.
   

Recharge Your PowerCore

USB-C port is for input only

Specifications

Important Safety Instructions

When using this product, basic precautions should always be followed, including the following:

1. Store product in a cool and dry place.
2. Do not store the product in hot or humid environments.
3. Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
4. Operating temperature should be between 32°F to 104°F / 0℃ to 40℃.
5. Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
6. If the product is not used for long periods of time, you should change and discharge once every three months.
7. When charging a device, the product may feel warm, this is a normal operating condition and should not be cause for concern.
8. In normal conditions, the battery performance will decline over several years.
9. Do not dispose of the product in heat or fire.
10. Do not clean the product with harmful chemicals or detergents.
11. Misuse, dropping, or excessive force may cause product damage.
12. When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.

This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

Notice

Declaration of Conformity

Hereby, Anker Innovations Limited declares that the product type A1229 is in compliance with Directive 2014/30/EU & 2011/65/EU & 2001/95/EC The full text of the EU declaration of conformity is available at the following internet address: https://www.anker.com

Anker Technology (UK) Limited
GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United
Kingdom
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon,
Hong Kong
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany

GB Declaration of Conformity

Hereby, Anker Innovations Limited declares that the product type A1229 is in compliance with following Directives: Electromagnetic Compatibility Regulations 2016, The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012. The full text of the GB declaration of conformity is available at the following internet address: https://www.anker.com

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio / TV technician for help.

The following importer is the responsible party:

Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: 1-800-988-7973

IC Statement

This device complies with Industry Canada license‐ICES-003. Operation is subject to the following two conditions: ( 1 ) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Customer Service

18-month limited warranty*

Lifetime technical support

support@anker.com

(US/CA) +1 (800) 988 7973
(UK) +44 (0) 1604 936200

Please note that your rights under applicable law governing the sale of consumer goods remain unaffected by the warranties given in this Limited Warranty.

For FAQs and more information, please visit: anker.com/support

@Anker
@Anker Japan
@Anker Deutschland
@AnkerOfficial
@Anker_JP
@Anker

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>