UGEARS Combine Harvester 3D Self Propelled Instruction Manual
- June 15, 2024
- UGEARS
Table of Contents
UGEARS Combine Harvester 3D Self Propelled
Assembly Instructions
Remove model parts from the hanger board as illustrated below. Be careful not to break parts. If a part is not removed easily, carefully cut it out with a knife. This model is intended for self-assembly without glue. If you have difficulty installing the axles, try waxing them with a regular candle. All moving parts can also be waxed during assembly to reduce friction when operating the model.
Warning: Do not use a lighted candle.
Symbols
- Wax the part with a regular candle (rub with a candle).
- Check size.
- Break off or cut out
- Pay attention. Check for correct orientation or positioning.
- Spare parts.
- Cut crosspieces before removing the part from the board.
Axle
This is not a structural component; it is a tool for measurement and assembly.
INSTALLATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>