Extron FLEX55 AC Plus USB 130 US Power Modules User Guide
- June 4, 2024
- Extron
Table of Contents
Extron FLEX55 AC Plus USB 130 US Power Modules
Setup Guide
The Flex55 AC+USB 130 US Power Module provides AC, USB Type-A and USB Type-C
power outlets for powering and charging compatible mobile devices. The
following guide provides the steps to install and secure the power module to
select Flex55 and Cable Cubby enclosures (see the ATTENTION below before
installing the power module).
The power module supplies up to 29.5 total watts.
NOTE: To view the power specifications, see www.extron.com.
Front Panel and Side Features
Figure 1. Flex55 AC+USB 130 US Power Module
- A USB Power Outlets:
- USB Type-A — supports up to 10 watts (5VDC up to 2A). When both USB ports are used, the Type-A port drops to 0.5A.
- USB Type-C — supports up to 27 watts.
- B AC Power Outlet — supports 120VAC, 50 to 60Hz, 6A Max.
- C Mounting Clips — there are four mounting clips on the unit, two on the top side of the module and two on the bottom. These help secure the unit to the mounting frame or bracket.
ATTENTION:
- Always consult with a professional installer.
- Follow all national and local building and electrical codes that apply to the installation site.
- The installation must always be in accordance with the applicable provisions of National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical Code part 1, section 16. The power supply shall not be permanently fixed to building structure or similar structure.
(National Electrical Code) ANSI/NFPA 70, article 725, et du Code canadien de l’électricité, partie 1, section 16.)
Installing the Flex55 AC+USB 130 US Power Module
The following illustrations show the process for installing the Flex55 AC+USB
130 US Power Module into the Cable Cubby Flex55 compatible enclosure
Figure 2. Installing the Flex55 AC+USB 130 US
Removing the Flex55 AC+USB 130 US
The following illustration shows the process for removing the Flex55 AC+USB
130 US Power Module from the Cable Cubby F55 UT enclosure, using the provided
pry tool. This process applies to any compatible Flex55 and Cable Cubby
enclosure
Figure 3. Flex55 AC+USB 130 US Power Module Removal
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the Extron Safety and Regulatory Compliance Guide on the Extron website.
© 2021 Extron — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805,
800.633.9876
68-3652-50 Rev. A 06 2
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>