HOLLYLAND Lark C1 Wireless Lavalier Microphone User Manual

June 14, 2024
HOLLYLAND

HOLLYLAND Lark C1 Wireless Lavalier Microphone

HOLLYLAND-Lark-C1-Wireless-Lavalier-Microphone-product

The configuration is based on the product package and is subject to the actual quantity of equipment purchased.

PACKING LIST

LARK C1 SOLO [JX•1 to RX•1) Wireless Microphone System

HOLLYLAND-Lark-C1-Wireless-Lavalier-Microphone-fig-
\(1\)

LARK C1 DUO (JX2 to RX1) \/v1reless Microphone System wth a Charging Case

HOLLYLAND-Lark-C1-Wireless-Lavalier-Microphone-fig-
\(2\)

The configuration is based on the product package and is subject to the actual quantity of equipment purchased.

PRODUCT INTRODUCTION

HOLLYLAND-Lark-C1-Wireless-Lavalier-Microphone-fig-
\(3\)

PRODUCT INSTALLATION

  1. The TX automatically turns on after it Is taken out of the charging case. Simply clip the TX on the cloth
  2. Connect the RX to a mobile phone.
  3. Charge the mobile phone via the RX

PRODUCT FUNCTION

Noise Cancellation Function

Charging Case Battery Level

  1. Steady Blue Light Device connected/Smart noise cancellation off by default
    Steady Green Ught: Smart noise cancellation on
    Press the yellow button on the TX to enable the smart noise cancellation function. After the function is enabled, the indicator light turns green.

  2. Flashing Ught: Charging
    Steady Light: Fully charged

PRODUCT FUNCTION

Manual Pairing

HOLLYLAND-Lark-C1-Wireless-Lavalier-Microphone-fig-
\(10\)

After the receiver is connected to the mobile phone, press and hold the “ button on the TX and the’ ‘ button on the RX for 3s.

  • The TX and RX have been paired with each other in the factory before shipping, They need to pair with each other again if they are disconnected.

PARAMETERS

HOLLYLAND-Lark-C1-Wireless-Lavalier-Microphone-fig-
\(12\)

APP

LarkSound
Developed exclusively for Lark wireless microphones, the LarkSound app is a perfect design to work together with the microphones, Various functions, such as smart mode setting, parameter configuration, and firmware upgrade, can be achieved in LarkSound.

HOLLYLAND-Lark-C1-Wireless-Lavalier-Microphone-fig-
\(13\)

SUPPORT

If you encounter any problems in using the product, please contact the Hollyland Support Team via the following ways:

Note:
The frequency range and wireless TX power of the device vary by country and region.

Safety Precautions
Do not place the product near or inside heating devices (including but not limited to microwave ovens, induction cookers, electric ovens, electric heaters, pressure cookers, water heaters, and gas stoves) to prevent the battery from overheating and exploding. Do not use non-original charging cases, cables, and batteries with the product. The use of non-original spare parts may cause electric shock, fire, explosion, or other dangers.

FCC Requirement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operations are subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operations.

FCC Radiation Exposure Statement:
The device has been tested and complies with FCC SAR limits.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if it is not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the distance between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals