HUSKY Drafting Tall Office Chair Instruction Manual
- June 14, 2024
- Husky
Table of Contents
HUSKY Drafting Tall Office Chair
CARE AND USE INSTRUCTIONS
Thank you for selecting a WeatherBeater® Floor Liner from Winfield
Consumer Products. Your new front floor liners are custom molded to fit your
Toyota Tacoma equipped with an automatic transmission. The liners are made to
take the place of your factory floor mats. For correct fit, it is necessary to
remove the factory floor mats before installing your new floor liners.
However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and
extremely tough and durable. The easiest way to clean your liners is with a
damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use
of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products
make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA TACOMA FRONT FLOOR LINERS –
MODELS WITH AN AUTOMATIC TRANSMISSION
**LEFT OR DRIVER’S SIDE
**
**RIGHT OR PASSENGER’S SIDE
**
TO EASE INSTALLATION OF YOUR TACOMA FRONT LINERS, MOVE THE FRONT SEATS TO
THEIR MOST REARWARD POSITION. WITH THIS DONE, INSTALL THE LINERS POSITIONED AS
SHOWN ABOVE. THE DRIVER’S SIDE LINER ATTACHES TO THE FACTORY TWIST-LOCK MAT
RETAINERS LOCATED IN THE VEHICLE FLOOR PAN. TAKE CARE TO MAKE SURE THE LINER
IS SECURELY AFFIXED. ONCE LINERS ARE IN PLACE, REPOSITION THE SEATS AS
DESIRED.
THE PASSENGER SIDE LINER IS SECURED IN PLACE WITH TWO (2) INCLUDED CLIPS. TO
INSTALL THESE CLIPS, PLEASE REVIEW THE INSTRUCTIONS ON THE BACK OF THIS PAGE.
INCLUDED IN YOUR PACKAGING YOU WILL FIND TWO (2) COMPONENT BAGS, EACH WITH A FASTENER DESIGNED TO AID IN SECURING THE PASSENGER SIDE LINER IN PLACE. THE CLIPS WILL PROVIDE A WATER-TIGHT SEAL SO MOISTURE WILL NOT PASS THROUGH TO THE FLOOR BELOW. TO INSTALL THE CLIPS, FIRST REMOVE THEM FROM THE BAGS AND UNSCREW THE CAP FROM THE BASE (SEE IMAGE 1 BELOW). NEXT, INSERT THE THREADED PORTION OF THE BASE INTO THE HOLE IN THE DRIVER’S SIDE LINER, INSERTING IT FROM THE BACK SIDE OF THE LINER (SEE IMAGE 2 BELOW). WITH THIS DONE INSTALL THE LINER IN THE VEHICLE AND, USING A COIN, SCREWDRIVER OR SIMILAR TOOL, SCREW THE BASE OF THE FASTENER INTO THE CARPETING (SEE IMAGE 3). LASTLY, AS SHOWN IN IMAGE 4, INSTALL THE CAP ONTO THE BASE. TIGHTEN EACH CAP UNTIL IT MEETS RESISTANCE, DO NOT OVER TIGHTEN.
HERE IS A LINK TO AN INSTALLATION VIDEO: https://www.youtube.com/watch?v=d29LSqPA9Us
Customer Support
View the Husky Liner Lifetime Warranty at www.huskyliners.com/lifetime- warranty
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>