POLAR G-series Chest Freezer Instruction Manual

Chest Freezer
Instruction manual

Model
GH337 / GH339

Safety Instructions

• Position on a flat, stable surface.

• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.

• Consult Local and National Standards to comply with the following:
  – Health and Safety at Work Legislation
  – BS EN Codes of Practice
  – Fire Precautions
  – IEE Wiring Regulations
  – Building Regulations

• DO NOT use jet/pressure washers to clean the appliance.

• DO NOT use the appliance outside.

• DO NOT use this appliance to store medical supplies.

• DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.

• DO NOT store products on top of the appliance.

• Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.

• Always switch off and disconnect the power supply to the unit before cleaning.

• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

• If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard.

• Polar recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.

• Polar recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

• Avoid prolonged direct skin contact with frozen food, ice or the inner walls.

Warning: Risk of Fire

• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
  Warning: Keep all ventilation openings clear of obstruction. Unit should not be boxed in without adequate ventilation.

• Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
  Warning: Do not damage the refrigerant circuit.

• Warning: Do not use electrical appliances inside the food storage compartments of the appliance.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.

Pack Contents

The following is included:
POLAR Chest Freezer  Baskets
Instruction Manual
POLAR prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

Installation

Not for use in vans or trailers, food trucks or Similar vehicles.
If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand.

1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.

2. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 20cm clearance on the top.
   NEVER LOCATE NEXT TO A HEAT SOURCE.

3. Set the brakes on the castors to keep the appliance in position.

Avoid positioning the unit in direct sunlight or damp areas.
Before using the appliance for the first time, clean the baskets and interior with soapy water then dry well.
Warning: When positioning the appliance, ensure the supply cord is not trapped or damaged.
Warning: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.

Operation

Control Panel

Turn On

1. Close the lid of the appliance.
2. Connect the appliance to a mains power supply.

Set the Operating Temperature

1. Press the SET button for 3 seconds. The display will flash.
2. Press the buttons to display the required temperature.
3. Press the SET button to store the temperature.

Freezing tips

• Allow hot food to cool prior to freezing.

• For best and fastest freezing, it is better to split food into smaller portions.

• The pre-set position of baskets has already been set in the most efficient use of this unit.
  Ensure that baskets are not over-filled. It is important that the lid should close onto the body for the appliance to refrigerate efficiently.

• To prevent food waste from drying out (freezer burns), place food in airtight packaging.

• Take note of the “use by” date and recommended freezer storage time. Ensure that food to be used is made easily accessible.

• Storage time varies and depends on the food type and packaging. Strictly observe the food producer’s instructions on the packaging.

• To avoid contamination of food, please respect the following instructions:
  – Avoid opening the lid too often. Opening the lid for long periods can cause a significant increase of the temperature in the appliance.
  – If the gasket or seal is damaged or deformed, energy consumption will increase. To restore efficiency replace gasket.
  – If the refrigerating appliance is left empty for long periods, switch it off. Then defrost and clean it thoroughly. Let it dry well and leave the door open to prevent mould developing within the appliance.
  – Clean regularly surfaces that can come in contact with food and accessible drainage system.
  – Store raw meat and fish in suitable containers in the freezer, so that they are not in contact with or drip onto other food.

Cleaning, Care & Maintenance

• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.

Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also increase the amount of ice and condensation.
Excessive ice will result in longer running times that will increase energy consumption and increase the deterioration of components.

Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.

Defrost
When any ice built-up reaches 5mm thick, a manual defrost process is required. To do this switch the freezer off at the power supply. Then, manually defrost the appliance. Never use sharp objects for scraping.

Troubleshooting

A qualified technician must carry out repairs if required.

plugged in correctly and switched on
Plug or lead is damaged| Replace Plug or lead
Fuse in the plug has blown| Replace the fuse
Mains power supply fault| Check mains power supply
The appliance turns on, but the temperature is too high/low| Too much ice on the evaporator| Defrost the appliance
Condenser blocked with dust| Clean the condenser
Lid not shut properly| Check lid is shut and seals are not damaged
Appliance is located near a heat source or air flow to the condenser is being interrupted| Move the refrigerator to a more suitable location
Ambient temperature is too high| Increase ventilation or move appliance to a cooler position
Appliance is overloaded| Reduce the amount of food stored in the appliance
The appliance is leaking water| The appliance is not properly levelled| Adjust the screw feet to level the appliance (if applicable)
The appliance is unusually loud| Loose nut/screw| Check and tighten all nuts and screws
The appliance not installed in a level or stable position| Check installation position and change if necessary

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may subject to change without notice.

Model| Voltage| Power| Current| Temperature
Range| Refrigerant| Dimensions
HxWxDmm| Weight
(kg)
---|---|---|---|---|---|---|---
GH337| 220-240V∼
50Hz| 170W| 1.3A| -18°C — -24°C| R600a| 870 x 1435 x 745| 67
GH339| 190W| 1.3A| -18°C ty -24°C| R600a| 870 x 2035 x 745| 87
Model| Net usable capacity (L)| Gross Capacity (L)| Climate Class| Design type
---|---|---|---|---
GH337| 378| 385| Tropical| Free standing
GH339| 581| 587| Tropical| Free standing

Note: For optimal product performance and efficiency, please ensure to mind the net usable capacity (load limit) when filling.

Impact of temperature settings on food waste:
In order to reduce food waste from decomposition or dehydration, this appliance should be operated in its designated operating range.
Optimum temperature for food storage: -18°C

To order spare parts please contact your Polar Stockist:

****https://www.polar-refrigerator.com/stockist

Minimum period of spares parts to be available:
Door handles, door hinges, trays and baskets will be made available for a minimum of seven years after the last unit of the model is placed on the market. A further selection of technical spares will also be available to Professional users for a minimum of seven years. Door gaskets will be made available for a minimum of 10 years.

Model information can be found on the product database:

https://eprel.ec.europa.eu/screen/product/refrigeratingappliancesdirectsalesfunction

Model information can be found on the product:
The Model Identifier can usually be found on the inside wall and on the reverse of the unit.

Note: Polar offers a 2 year minimum warranty, please contact the authorised representative for more details.

Electrical Wiring

POLAR appliances are supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
POLAR appliances are wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Disposal
EU regulations require refrigeration product to be disposed of by specialist companies who remove or recycle all gasses, metal and plastic components.
Consult your local waste collection authority regarding disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.
Alternatively call the POLAR helpline for details of national disposal companies within the EU.

Compliance
**** The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
POLAR products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

G Series Chest Freezer – 385L
G Series Chest Freezer – 587L| GH337 (& -E)
GH339 (& -E)
Application of Territory Legislation &  Council Directives(s)| Low Voltage Directive (LVD) – 2014/35/EU
Electrical Equipment (Safety) Regulations 2016
(BS) EN 60335-1:2012 +A11:2014 +A13:2017 +A1:2019 +A14:2019 + A2:2019
(BS) EN 60335-2-24:2010 +A1:2019 +A2:2019 +A11:2020
(BS) EN 62233:2008
Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU – recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016 (5.1. 2016/1091)
(BS) EN 55014-1:2017 +A11:2020
(BS) EN 55014-2:2015
(BS) EN IEC 61000-3-2:2019 +A11:2021
(BS) EN 61000-3-3: 2013 +A1:2019
Ecodesign energy-related products Directive 2009/125/EC; Regulation (EU)
Regulation (EU) 2019/2019 ecodesign requirements for refrigerating appliances
EN 62552
Restriction of Hazardous Substances Directive
(Rol-15) 2015/863 amending Annex II to Directive 2011/65/EU
Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic
Equipment Regulations 2012 (S.1. 2012/3032)
Producer Name| Polar

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

Co. Cork troland
UK| +44(0)845 145 2887
---|---
Eire

http://www.polar-refrigerator.com/
GH337_GH339_ML_AS_v1_2022/11/29

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>