TELTONIKA FMP100 Cigarette Lighter Tracker with Buzzer Owner’s Manual

TELTONIKA FMP100 Cigarette Lighter Tracker with Buzzer Owner’s Manual

DEVICE YOUR KNOW

• SIDE VIEW (WITHOUT COVER)
• FRONT VIEW (WITHOUT COVER)

DEVICE YOUR UP SET

BATTERY THE CONNECT AND CARD SIM-NANO-MICRO INSERT TO HOW

• NANO-SIM TRAY INSERT
  Insert the NANO-SIM tray removal tool into the hole on the NANO-SIM card tray and then push until the tray pops out.

• DEVICE COVER SPLIT
  split device cover to access battery connector inside.

• BATTERY CONNECTION
  Connect the battery as shown to device.

• ATTACHING COVER BACK
  Gently close device cover back.

• NANO-SIM CARD INSERT
  Insert NANO-SIM card as shown with PIN request disabled or read Security info’ how to enter it later in Teltonika Configurator’. Make sure that NANO- SIM card cutoff corer is pointing forward to slot. NANO-SIM slot 1s closer to PCB, NANO-SIM slot 2 is the upper one.

• DEVICE IS READY
  Screw in all screws. Device is ready to be mounted.

PC CONNECTION (WINDOWS)

1. Power-up FMP100with DC voltage (10 – 30 V) power supply using supplied power cable. LED’s should start blinking, see “LED indications™.

2. Connect device to computer using Micro-USB cable or Bluetooth connection:

   • Using Micro-USB cable
   • You will need to install USB drivers, see “How to install USB drivers (Windows)*
   • Using Bluetooth
   • FMP100 Bluetooth is enabled by default. Turn on Bluetooth on your PC, then select Add Bluetooth or other device >
     Bluetooth. Choose your device named – “FMP100_last_7_imei_digits”, without LE in the end. Enter default password 5555, press Connect and then select Done.

3. You are now ready to use the device on your computer.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>