DREO DR-HTF005S Tower Fan Smart Voice Control User Manual

DREO DR-HTF005S Tower Fan Smart Voice Control

Your support means the world to us. We hope you enjoy our product as much as we did creating it.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: READ ALL CAUTIONARY MARKINGS ON THE APPLIANCE AND SAFETY INSTRUCTIONS IN THE USER MANUAL BEFORE USE.

Do not cover the air inlet and outlet while in operation.
Do not use the fan near flammables and combustibles.

General Safety

1. Children shall not play with the appliance. Cleaning and maintenance shall not be performed by children without supervision.
2. Use the appliance as described in the user manual only. Any other use not recommended in the user manual may cause fire, electrical shock, or personal injury.
3. This appliance can be used by children aged above 8 years and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of this appliance in a safe way and understand the hazards involved.

Operation Safety

1. Place the appliance on a flat, dry surface before use.
2. Do not immerse in water and any other liquids.
3. Do not use the appliance until the base is installed.
4. Do not insert your fingers, pencil or any other objects into the grilles while in operation.
5. Do not dismantle, repair, or modify. All servicing should be performed by qualified personnel.

Electricity Safety

1. Make sure that the voltage of your electricity supply is the same as that indicated on the appliance.
2. Always unplug before cleaning or leaving the appliance unused for a long period of time. Keep your hands dry when plugging/unplugging.
3. Do not operate any fan with a damaged cord or plug. Discard the fan or return it to an authorized service facility for examination and/or repair.
4. Do not run the cord under the carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or appliances. Arrange the cord away from the traffic area so that it will not be tripped over.
5. WARNING: To reduce the risk of fire or electric shock, do not use this tower fan with any solid-state speed control device.
6. Use 24V/1A power adapter only. Turn off the appliance before plugging.

FOR HOUSEHOLD USE ONLY READ AND SAVE THESE INSTRUCTIONS

Gentle Reminder
Check the appliance regularly and refer to TROUBLESHOOTING or contact our customer support if it shows any of the following signs:

• The power cord or plug is damaged.
• Loud noise, unusual smell, or excessive heat.

Specifications

• Model: DR-HTF005S
• Power Supply: 24V=1A
• Rated Power: 24W
• Power Adapter:
  • Input : 100-240V -50/60Hz
  • Output: 24V=1A
• Remote Control Battery: CR20253V

ASSEMBLING YOUR TOWER FAN

Assembly Instructions
When using the appliance for the first time, remove the wraps and attach the parts by following the steps below.

Keep two base halves in a crossed position, then insert pegs on one half onto the slots on the other half.

Press down on the edges to click two base halves together.

Fit the base onto the bottom of the fan by aligning the arrows on the underside. Make sure the jutting points in the center of the base are fitted into the recesses on the fan.

Rotate the base clockwise to lock in place.

Put the fan upright, then plug the power adapter into the power input (located at the back of the fan), and into the power outlet.

CAUTION: Do not operate the tower fan if the base has not been installed.

Package Contents

CONNECTING TO YOUR TOWER FAN

Before connecting the appliance to your mobile device, please scan the QR code on the left or go to the app store and search “Dreo”, then select and download the app.

You can use the Oreo app to connect your Smart Tower fan to Amazon Alexa or Google Assistant. Please follow the in-app instructions to set up your voice assistant.
NOTE: You must create an Oreo account to access voice assistants.

1. Launch Oreo and sign in or create an account by following in-app instructions.

2. Enable Bluetooth on your mobile device and plug in your tower fan.

3. Tap + Add Device and select the tower fan you want to link.

4. Hold the Oscillation button for 5 seconds to start WiFi connection settings.
   (Tip: The WiFi ‘9 will keep flashing when pairing.)

5. Follow in-app instructions to complete the WiFi connection.

6. You’re now ready to control the appliance on your app.
   (Tip: To restart connection settings, hold the Oscillation button again for 5 seconds.)

KNOWING YOUR TOWER FAN

Control Panel

LED Display

NOTE:

• The display will turn off after 1 minute (after 5 seconds in sleep mode).
• Wake the display up with any button.
• The display will not turn off when the auto-on timer is enabled.

Getting the Most out of Your Tower Fan

1. It’s not an air conditioner.
2. Remove any tall obstacles that might block the airflow from the fan.
3. Combine with your AC unit to get cooler air throughout the room.
4. Position the tower fan closer to you to get more direct airflow.
5. Place a bucket of ice in front of the fan for an extra cooling boost.

USING YOUR TOWER FAN

General Operations

Working Modes

Additional Features

Remote Control

Battery Replacement

1. Press the locking button to pop out the battery holder.
2. Replace with the same battery type with the(+) side facing up.
3. Push in the holder until securely locked into place.
   Note: If the indicator on the remote control doesn’t turn on anymore, please consider replacing the battery.

WARNING: Chemical Burn Hazard. Keep batteries away from children. This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the battery, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

The batteries must be disposed of properly, including keeping them away from children. Even used cells may cause injury.

CLEANING AND MAINTENANCE

• Outer Surface
  Gently wipe off the dust with a soft, dry cloth.

• Grilles & Blades
  Remove the dust using a vacuum or air duster.

• Base

Press on the lock sign here and rotate counterclockwise to release the base from the fan, then press the tabs on the edges to detach the base halves from each other.

CAUTION

1. Always unplug the fan before any cleaning or maintenance to avoid the risk of fire, electric shock, or injury to persons.
2. Do not immerse in water or get water inside the motor housing.
3. Do not use any chemical agents when cleaning the fan.
4. Store in a cool, dry place and cover it to protect it from dust.

Rear Grab

WARNING
To reduce the risk of electrical shock and injury to persons, turn off and unplug the appliance before any cleaning and maintenance.

1. Remove the screw on the top of the rear grille with a Philips screwdriver.
2. Lift up the grille and pull it out.
3. Clean the dust on the blades using a vacuum cleaner or air duster. Rinse the rear grille under running water or with a clean, damp cloth.
4. Dry up, then install the grille and the screw back, making sure the pegs are fully inserted into the groove at the bottom.

TROUBLESHOOTING

My fan won’t turn onl

1. Make sure that the cord is connected to a powered outlet and the mains voltage corresponds with the voltage indicated on the fan.
2. Check if the power adapter is securely inserted into the power outlet and the tower fan.
3. Adapter protection may have been activated. Please unplug the tower fan and let it rest for 10 seconds before re-plugging in.

My fan is shaky and wobbling!

1. Place the fan on a flat, level surface.
2. Incorrect installation might also cause shakiness. Please refer to the assembly instructions in page 3-4.

My fan is making vibration and noise!

1. Place the fan on a flat, level surface.
2. Be sure not to insert anything into the air inlet and outlet.

If your problem is not listed or still persists, please contact our Customer Support (see page 15).

OREO CUSTOMER CARE

Default 12-Month Warranty
This appliance is covered by an Oreo warranty for 12 months from the date of its original purchase.

Extend Your Warranty

Extend your warranty by registering your new appliance on our website
https://dreo.com/warranty.

The warranty will not apply In cases of:

1. Accident, misuse, or repairs performed by unauthorized personnel.
2. Any unit that has been tampered with or used for commercial purposes.
3. Normal wear and tear of wearable parts.
4. Use of force, damage caused by external influences.
5. Damage caused by non-observance of the User Manual, e.g. connection to an unsuitable mains supply or noncompliance with the instructions.
6. Partially or completely dismantled appliances.
7. Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized by Oreo.

We can only provide after-sales service for products that are sold by Oreo or Oreo-authorized retailers and distributors. If you have purchased the appliance from a different place, please contact your seller for return and warranty issues.

FCC Statement

This device complies with Part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for Consumer ISM equipment, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Please note that changes or modifications to this product are not expressly approved by the party responsible for compliance and could void the user’s authority to operate the equipment.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/rV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

“9 888-290-1688
support@dreo.com
www.dreo.com

www.dreo.com
1=1, Shenzhen Hesung Innovation El Technology Co., LTD
26F, Bldg A7, Creative City, Shenzhen, China MADE IN CHINA 5018396

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>