Vileda 166710 1 In 2 Microfibre Flat Floor Spray Mop User Guide

Vileda 166710 1 In 2 Microfibre Flat Floor Spray Mop

INTRODUCTION

Here are general steps you can follow:

1. Assembly
   • Start by assembling the mop according to the instructions provided in the manual.
   • This usually involves attaching the mop head to the mop base and connecting the handle.
2. Filling the Reservoir
   • Check if your mop has a built-in water reservoir. If it does, fill it with the recommended cleaning solution or water according to the manufacturer’s instructions.
3. Attaching the Cleaning Pad
   • If your mop uses disposable or reusable cleaning pads, attach them to the mop head. Follow the instructions to ensure a secure fit.
4. Spraying the Floor
   • Hold the mop handle and press the spray trigger or button to release the cleaning solution onto the floor.
   • Some mops have a spray nozzle on the mop head that disperses the solution in front of the mop as you move.
5. Mopping
   • Glide the mop over the floor, moving it back and forth to cover the desired area.
   • The microfiber pads are effective at picking up dirt and grime.
6. Refilling the Reservoir
   • If the reservoir runs out of cleaning solution, refill it as needed.
7. Cleaning the Mop Head
   • Depending on the model, the mop head may be machine washable or require hand washing. Refer to the manual for specific cleaning instructions.
8. Storage
   • When you’re finished cleaning, store the mop in a dry place. Some models have a collapsible handle for convenient storage.

FAQs

1.Can I use Vileda's 1-2 Spray Mop system on any surface?

The flat mop is ideal for cleaning floor tiles linoleum and laminate floors. However, the moisture of the pads is also suitable for parquet and wood floors.

Can I use a cleaning solution?

Yes, we would recommend the 1-2 Spray Active Cleaner Solution, which is fully diluted and ready to go. Alternatively you can simply fill the integrated tank with water and a small amount of your preferred detergent if you wish, or just water.

I need a refill, where can I get one?

Refills are available in our online shop. Simply type in the name of your product or cleaning tool and a refill pack will show up.

What happens if my mop stops spraying?

Use a commercially available descaling product like Citric Acid and follow the instruction of the manufacturer to prepare around 250ml of descaling solution. Empty the product of the remaining water, pour in the descaling solution, and squeeze the trigger a couple of times to clean out the mop and nozzle. Allow it to react for 8 hours (or follow the instructions on the solution you are using) squeeze the trigger a couple of times before emptying the descaling solution. You will also need to stick a pin in the bottom of the nozzle and clean around this to get rid of any debris.

How do I connect the mop together?

First place the mop head flat on the floor with the connector in the upright position. Then place the handle over the connector and push down firmly until you hear a click.

. I have connected the handle on the wrong way, how do I change it?

First place the mop head flat on the floor with the handle in the upright position. Then place your feet on top of the mop head on either side of the handle. Carefully pull the handle up until it is released.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>