Acquaer 1 HP 110V Deep Well Submersible Pump Installation Guide

June 14, 2024
Acquaer

Acquaer 1 HP 110V Deep Well Submersible Pump

Product Usage Instructions

Wiring Instructions

Connect the wires according to the following color scheme:

  • BLACK – LIVE WIRE (L)
  • BLUE – NEUTRAL WIRE (N)
  • YELLOW – GROUND WIRE (PE)

Splice Kit Instructions

Identify the accessories from the splice kit

  • Black Heat Shrink Tubing
  • White Heat Shrink Tubing
  • Butt Connector
  • Rubber Splicing Tape
  • Hot Melt Adhesive
  • Waterproof Electrical Tape

Follow the below steps to splice the wires:

  1. Place B (White Heat Shrink Tubing) over each individual wire.
  2. Firmly crimp each splice with crimping pliers.
  3. Heat B with a heat gun or lighter.
  4. Wind D (Rubber Splicing Tape) on the butt splice connections.
  5. Wrap the three wires together with E (Hot Melt Adhesive).
  6. Slide A (Black Heat Shrink Tubing) over the connection and evenly heat it on all sides.
  7. Wind F (Waterproof Electrical Tape) over the shrink tubing A and cable.

CAUTION

  • The pump’s voltage must match your power supply.
  • Please install external check valves at the discharge to prevent flowback.
  • The pump must be installed in a 4” or larger well casing with torque arrestors.
  • Please don’t run the pump dry. Make sure it is fully submerged in water.
  • The pump is designed for clean water. Please make sure all fines and foreign matters in the well are removed before installation.
  • Please keep the pump at least 10ft from the bottom of well,and above the well screen or casing perforations.

For more information on installation, please read the user manual.

WIRING INSTRUCTIONS

Ref. accessory numbers A, B, C, D, E & F on prev. page of splice kit

Warning

  • Match Each Other Correctly

Acquaer-1-HP-110V-Deep-Well-Submersible-Pump-fig-4

  1. Place B over each individual wire.
  2. Firmly crimp each splice with crimping plier.
  3. Heat B with a heat gun or lighter.
  4. Wind D on the butt splice connections.
  5. Wrap the three wires together with E.Acquaer-1-HP-110V-Deep-Well-Submersible-Pump-fig-7
  6. Slide A over the connection and evenly heat it on all sides.
  7. Wind F over the shrink tubing A and cable.

ATTENTION:  BLACK-LIVE WIRE (L), BLUE-NEUTRAL WIRE (N), YELLOW-GROUND WIRE (PE).

Extension Cord Recommendations

Acquaer-1-HP-110V-Deep-Well-Submersible-Pump-fig-8

Splice Kit

Acquaer-1-HP-110V-Deep-Well-Submersible-Pump-fig-1

  • A: Black Heat Shrink Tubing
  • B: White Heat Shrink Tubing
  • C: Butt Connector
  • D: Rubber Splicing Tape
  • E: Hot Melt Adhesive
  • F: Waterproof Electrical Tape

ATTENTION

  • BLACK – LIVE WIRE (L),
  • BLUE – NEUTRAL WIRE (N),
  • YELLOW – GROUND WIRE (PE).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals