HULKMAN Alpha 65 Steps To Jump Start Your Vehicle User Guide
- June 14, 2024
- hulkman
Table of Contents
HULKMAN Alpha 65 Steps To Jump Start Your Vehicle User Guide
STEPS TO JUMP START YOUR VEHICLE
| 
| 
---|---|---
Step : 1
Insert the jumper cable into the booster and connect the clamps to the car
battery| Step : 2
‘’READY’’ sign shows on the screen.| Step : 3
Start your car engine.
ABOUT THE FORCE START FUNCTION
Why the screen shows nothing when you try to start your car ?
If the screen doesn’t display anything when you have correctly connected the
clamps to your car, it means that your battery voltage is extremely low, you
can use the Force Start Function to enter boost mode.
steps to fix your problem:
- Check the clamps connection and the product’s battery is above 20%.
- Press the Power Button and Flashlight Button simultaneously for 2-3 seconds.
- The screen shows “READY”, and go back to start engine ignition.
WARNING: WHEN USING THE FORCE START FUNCTION, AUTO-DETECTION AND SAFETY FEATURES WILL BE DISABLED.
ABOUT THE ERROR CODES
| Error Code | Reason | Solution |
|---|---|---|
| ‘’+’’and ‘’-’’ poles of battery clamps reversed. | Reverse the clamps and |
ensure the correct connection
| The voltage of the car battery is between 2-8V| Press the Power Button and
Flashlight Button simultaneously for 2-3s to start force output. (Force Start
Function)
| The product’s operating temperature is too high / low
Charge the device at extremely low or high temperature.| Please store it back
to where the temperature is between 32°F to 113°F.
Please charge the device at room temperature.
| Jump start the battery more than 5 times within 10 minutes, the product will
automatically enter the safe mode.| The safe mode will be off automatically
after 10 minutes waiting. (Please do not turn off the product during the
process)
ABOUT USB-A OUTPUT PORT
- Plug the cable into the USB-A output port.
- Press the Power Button.
ABOUT LED FLASHLIGHT
- Hold the Flashlight Button for 1-2s.
- Press briefly to switch the light modes.•50% Lumen Light → 100% Lumen Light → White Strobe Light → White SOS Light
CHARGER YOU ALPHA 65 JUMP STARTER
Fully charge your Alpha 65 jump starter in 45 minutes with our patented 65W
recharge technology.
Plug the cable into the USB-C
output port to charge your device.
THE CHARGER INCLUDED IN THE BOX IS A 10W WALL CHARGER. NOTE: 65W WALL CHARGER CAN BE PURCHASED SEPARATE
CONTACT US
https://support.hulkman.com 46 Smith Alley, Suite 200 Pasadena, CA 91103 +1
877-892-9703
service@hulkman.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>