INFANS Licensed Mercedes Benz G63 Kids Ride On Car Owner’s Manual

INFANS Licensed Mercedes Benz G63 Kids Ride On Car

PRODUCT INFORMATION

• Suitable age for 3+ Years
• Maximum user weight: 66 lbs.
• Adult assembly required

Assembly Instructions
Read and understand this entire manual before using it! Please keep this manual for future reference as it contains important information. Before first time use, charge the battery for at least 4-6 hours.

About New VehicIe
The purchase of your new Ride-On “Mercedes-Benz”, and the design of the enclosed product are subject to intellectual property protection owned by Daimler AG. They are used by Pinghu Little Sun Childs Vehicles CO.,LTD Trademarks, design patents, and copyrights are used with the approval of Mercedes-Benz G63

Specification

• Suitable age : 3+ Years
• Battery : 12V4.5AH x1
• Charge time : 8-12 hours
• Charge :
  • Input : depends on local voltage
  • Output : 12V 900mA
• Load capacity : Under 66 lbs.
• Size of car : 41.5″ X 24.5″ X 21.5″
• Speed : 3-5 km/hr

BATTERY INFORMATION

• Non-rechargeable batteries are not to be recharged.
• If removable rechargeable batteries are used, they are only to be charged under adult supervision.
• Remove rechargeable batteries from the product before charging.
• Do not mix old and new batteries. Do not mix different types of batteries: alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment, anode to anode, cathode to cathode.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Battery leakage and corrosion can damage this product. Dispose of batteries safely.
• Never short-circuit the battery terminals

Parts List

2

3

| Seat

Steering wheel

| 1

1

4| Car window| 2
5| Rearview mirror| 2
6| Trunk| 1
7| Tailstock| 1
8| Rear axle| 1
9| Driving motor| 2
10| Wheel| 4
11| Wheel cap| 4
12

13

| Pedal(right/ left)

Remote control

| 2

1

14| Charger| 1
15| Rear support| 2
A| 010 gasket| 6-8
---|---|---
B| Cotter pin| 4-5
C| M4X 12 screw| 26-28
D| M5 screw| 1
E| M5 nut| 1

Assembly tools required:

• Needle nose pliers (not included)
• Screwdriver (not included)

Parts Diagram

NOTE : Some parts shown are assembled on both sides ot vehicle

Safety
PREVENT INJURIES AND DEATHS:

• NEVER LEAVE CHILD UNATTENDED. ADULT DIRECT SUPERVISION IS REQUIRED.
• Always keep the child in view when a child is in the vehicle. This toy should be used with caution since skill is required to avoid falls or collisions causing injury to the user or third parties.
• Protective equipment should be worn.
• Never use in roadways, near cars, on or near steep inclines or steps, swimming pools, or other bodies of water. I always wear shoes, always sit on the seat.

CHOKING HAZARD! NOT suitable for children under 37 months.

ADULT ASSEMBLY REQUIRED

Rules for Safe Riding

• Keep children within Safe Riding Areas: Never use in the roadway near motor vehicles, on lawn space, on or near steep inclines or steps, swimming pools, or other bodies of water;
• Use the toy only on flat surfaces. Such as inside your house, garden, or playground.
• Never use it in the dark. A child could encounter unexpected obstacles and have an accident. Operate the vehicle only in the daytime or a well-lit area.
• It is prohibited to change the circuit or add other electric parts.
• Inspect wires and connections of the vehicle periodically.
• Do not let any child touch the wheels or be near them when the car is moving.
• This vehicle has adjustable play seat belts. Please instruct children how to tie the safety belt before use to guarantee security.

Operation Instruction

Turn the car upside down

1. Put an 010 gasket into the front axle
2. Install the front wheel;
3. Put another 010 gasket;
4. Insert the cotter pin into the hole of the front axle and fix the front wheel.;
5. Install the wheel hub;

Use the same way to install the front wheel on the other side

1. Put the rear axle in as shown;
2. Install the drive motor into the rear axle, connect the motor wire plug with the plug in the motor clamp port, and insert the motor into the clamp slot.;
3. Put the driving wheel on the rear axle and fix it;
4. Put an 010 gasket into the rear axle;
5. Insert the cotter pin into the hole of the rear axle and fix the rear wheel;
6. Install the wheel cap to the wheel

Use the same way to install the wheel on the other side

1. Install the pedal into the car body
2. Fix it with an M4*12 screw

1. Place the iron sheet as shown
2. Fix it with an M4*12 screw

Turn the car upright

1. Connect the music wire to the steering wheel

2. Install the steering wheel on the steering shaft. Align the hole from the steering wheel and steering shaft;

3. Fixed it with MS screw;

4. Put on the nut MS in the other side;

5. Install the trunk on the back of the car body as picture shown;

6. Fix it with Man 4*12 screw;

7. Fix the tailstock into the back of the car body;

8. Fix it with an M4*12 screw

9. Clip the windshield into the hole of the car body

10. Fix it with M4 * 12 screw;

Use the same way to clip the windshield;

1. Clip the Rearview mirror into the window;

2. Clip the window into the door;

3. Fix it with M4 * 12 screw;

4. Find the main power line and insert the plug-in of the power line into the corresponding socket of the receiver.

5. Put the upper cover seat into the corresponding buckle groove for internal fixation.

6. Slip the lower cover cushion flat into the upper cover cushion chuck

7. Fix with an M4*12 screw

Function Instruction

1. Power Button: Turn the vehicle on and off;
2. Shift Switch: Change the direction of the car, Forward-Stop-Backward
3. Horn Sound Button: Press it for horn sounds ;
4. Control Board;
5. USB port
6. Power display: see the battery power, to charge;
7. Socket: charge;
8. Light button: turn on or off the light;
9. Last song: switch songs, and long press will decrease volume;
10. Music button: play music;
11. Next song: switch songs, and long press will increase volume;
12. Power button: Long press it for 3 seconds, turn the vehicle on and off; Short press it for 1 second, to stop the music from the car
13. High-speed button: change the speed of the car more quickly
14. Low-speed button: change the speed of the car more slowly;
15. Wireless Technology: After connecting your mobile phone and the wireless device, the car can play music from your mobile phone
16. FM: FM radio

BATTERY WARNING

• Nonrechargeable batteries can not be charged.
• Only an adult can charge and recharge the battery.
• Different types of batteries can not be mixed.
• The battery needs to be placed with the correct polarity.
• The exhausted battery should be removed from the toy.
• Power terminals must not be short circuited.
• Do not provide dry batteries.

Use the Remote Control

NOTE : This product does not include the AAA(l. Sv) batteries. Only adults are allowed to use the remote control, and children are not allowed to touch it.

Operation manual : frequency binding is required for the first use (or after replacing the battery).

1. Take out the remote control, lift the battery compartment door on the back of the controller, and insert two AAA batteries. install the battery
2. Long press the frequency key for 2-4 seconds, Low speed LED light flashing
3. Turn on the power of the car, if the low-speed LED light keeps flashing until it stays on, then the frequency binding is successful.
4. If the frequency binding fails(Low speed LED light flashing), remove the battery and repeat steps 1 ~3
5. If the remote control is not operated for 10 seconds, the indicator light will go out and enter the power saving mode.
6. Button Description: 6 forward backward <l turn left [>turn right
7. Speed, P: emergency brake, Press it, and the running function will fail, press again, and it will release

Charge

1. Insert the charger jack into the charging hole of the car.
2. Plug the charger plug into the stable matching AC power supply as shown in the picture.

ATTENTION : Only an adult can charge and recharge the battery!

Charging

• Only an adult can charge and recharge the battery!
• When replacing a replaceable battery, first open the lid and take out the old battery. Put in the new battery, pay attention to the positive and negative poles, and cover the lid.
• Rechargeable batteries are to be removed from the toy before being charged.
• Owning charge protection function; all functions of the vehicle are not available when charging.

WARNING! PREVENT FIRE AND ELECTRIC SHOCK:

• Use the only rechargeable battery and charger supplied with your vehicle. NEVER substitute the battery or charger with another brand. Using another battery or charger may cause a fire or explosion.
• Do not use the battery or charger for any other product. Overheating, fir,e or explosion could occur.
• NEVER modify the electric circuit system. Tampering with the electric system may cause a shock, fire, or explosion or may permanently damage the system.
• Do not allow direct contact between battery terminals. Fire or explosion can occur.
• Do not allow any type of liquid on the battery or its components.
• Explosive gasses are created during charging. Do not charge near flammable materials. Charge the battery in a well-ventilated area ONLY.
• Rechargeable batteries are only to be charged under adult supervision. rechargeable batteries are to be removed from the toy before being charged. Must confirm before using the following work which is already finished:

Important! Before using the vehicle for the first time, the battery needs to be charged for 4 to 6 hours, no more than 15 hours. Only an adult can charge and recharge the battery. Check all the screws, cap nuts,s, and protective coverings regularly and tighten them as required.

Rules for Safe Riding

• Keep Children within safe riding areas:
• Never use in the roadway, near motor vehicles, on lawn space, on or near steep inclines or steps, swimming pools, or other bodies of water;
• Use the toy only on flat surfaces. Such as inside your house, garden, or playground
• Never use it in the dar. A child could encounter unexpected obstacles and have an accident. Operate the vehicles only in the daytime or well-litareasa.
• It is prohibited to change the circuit or add other electric parts.
• Inspect wires and connections of the vehicle periodically.
• Do not let any child touch the wheels or be near them when the car is moving. NEVER pick up the battery by the wires or charger. Damage can occur to the battery and may cause a fire. Pick up the battery by the case ONLY

Battery Replacement

Protector
This product is equipped with a self-resetting protector, when overloaded or in improper use, a self-resetting protector will automatically cut off the power supply for 15-20 seconds, and then restart. The self-resetting protector of the car is installed under the seat.

To avoid losing power, follow these guidelines:

• Do not overload the vehicle, maximum 66 Ibs.
• Do not tow anything behind the Vehicle.
• Do not immerse water or other liquids in electrical components, such as wiring, batteries, etc
• Do not tamper with the electric system and replacement must be conducted by professionals or under the guidance of technicians.

BATTERY REPLACEMENT AND DISPOSAL

• Check the charger’s wires, plugs, housing, and other components before use. Stop using the charger when damage is found until it is repaired.
• After some time, lubricate the parts of the vehicle with a small amount of lubricating oil to prevent wear and rust.
• Vehicles should be placed far away from fire sources and avoid long-term illumination. Keep it flat and facing upwards, not upside down or tilted; in wet weather, parked indoors or covered with waterproof cloth.
• Vehicles should be kept away from hot objects such as stoves and heaters. Plastic parts may melt. When charging, keep away from inflammable materials to prevent fire.
• After use, please charge in time, charging must be done by an adult. If you don’t have to use the battery for a long time, then charge it at least once a month to extend the battery life.
• Wipe the vehicle with a dry soft cloth. Non-waxy furniture polishing material can also be used instead of soft cloth to wipe plastic parts to achieve a surface finish effect.
• Do not use chemical solvents to wipe plastic parts of toys. Do not use soap and water to clean vehicles.
• Do not drive in rainy or snowy weather. Water can damage motors, electrical systems, and batteries.
• When you stop using or placing the product, please cut off the power supply of the product and dial all switches to the stop or close position.

Troubleshooting Guide

The above troubleshooting method, when the user is not available, please contact our customer service.

• The illustrations used in this specification are intended to illustrate the operation method and product structure of the product. If there is a small difference between the physical object and the illustrations, the physical object shall prevail.
• To improve the quality of the product, we may change part of the structure and appearance of the product without notice. Please understand.
• The packaging contains important information and must be kept.

FCC Statement

Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference.
2. this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>