Lydsto P1MINI Cordless Robotic Pool Cleaner Instruction Manual
- June 14, 2024
- Lydsto
Table of Contents
- Lydsto P1MINI Cordless Robotic Pool Cleaner Instruction Manual
- Warning
- Product introduction
- Parameter
- Notes required before use
- Notes required before use
- Notes required before use
- Instructions for use
- Product cleaning
- Product cleaning
- FAQ
- 1. Everything is normal during operation, but the robot will get stuck
- 2. The robot beeps and cannot operate after entering the water:
- 3. No response after opening the robot:
- 4. Even if the robot is fully charged, it only goes in one direction and
- 5. If the robot stops or gets stuck:
- 6. The robot’s running speed slows down and its suction becomes weak:
- 7. The charging port is corroded due to the electrolysis:
- NOTE
- FCC Radiation Exposure Statement
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Lydsto P1MINI Cordless Robotic Pool Cleaner Instruction Manual
Warning
- Read the manual carefully and use the cleaning robot according to the We shall not be liable for any loss or injury caused by improper use.
- Use only the accessories recommended or sold by the
- This robot is only suitable for flat-bottomed swimming
- Children Do not treat robot as a toy.
- Only original and authorized power adapters can be used.
- Adapter wiring can only be replaced by qualified
- Do not start the cleaning robot when it is out of
- When this machine charging, the charging adapter must be connected to the socket with leakage protection and
- Do not use cleaning robots when people or animals are in the
- The filter must be cleaned after
- Turn off the cleaning robot during maintenance, cleaning or not in
- The robotic pool cleaner should be stored in a cool and ventilated place, away from direct
- When charging, the cleaning robot should be placed in the shade and do not cover anything, so as to avoid overheating and damage to internal electrical components.
- Only certified professionals can dismantle
- Do not use the cleaner while the pool filter is
- The oil seal of the motor contains grease. If the grease leaks, it may cause water
- Due to the limitation of battery capacity, the cleaner is only suitable for swimming pools below 538 feet (50 square meters), otherwise, the cleaning effect will be
- If the robotic pool cleaner needs to be stored for a long time, it should be recharged every three months to keep the battery capacity between 40% and 60%. Please use only original and authorized power If the robotic pool cleaner does not charge for a long time, the battery voltage will be lower than the overdischarge protection voltage due to the self-discharge of the battery, which may cause serious damage.
- Do not use or store cleaning robots near any heat
- Do not Puncture the shell of the robot with nails or other sharp Do not knock, hit or throw the cleaning robot.
- Make sure the charging socket is dry before
Product introduction
The eco-friendly robotic pool cleaner is a new type of rechargeable self- cleaning robot that filters pool water to clean the poo
Parameter
Main engine|
---|---
Product name| Robotic Pool Cleaner S2
Product model| YM-S2-O3、YM-S2-O1
Rated power| 4OW
Charger input| 1OO-24OV~ 5O/6OHz
Charger output| 12.6V 1A
Battery capacity| 26OOmAh
Charging time| ≤4H
Water filtration| 128OGPH/8OLPM/5m³/h
Filtration capacity| 25Oμm
Velocity of movement| 52.5ft/min(16Meters / min)
Waterproofing class| IPX8
Product size| 25O25O25Omm
Storage temperature| -3O~65℃
Operating temperature| O~4O℃
Maximum endurance*| 7Omin
Net weight| 3.3kg
*Note: Battery life varies according to the user’s actual application environment.
Notes required before use
Notes required before use
Notes required before use
- After use, turn off the cleaning robot
- Do not touch the wall when robotic pool cleaner entering or taking out the swimming pool, so as not to scratch the wall or damage the robotic pool cleaner.
- Wait for the cleaning robot to leave the water surface for 10-15 seconds until it drains the water inside, then remove it from the water
- The robot will dock at the edge of the pool automatically after cleaning or running out of
- The attached catch hook is fixed to the pool pole, cleaning the robot’s handle and removing it from the
Instructions for use
- Charge the battery with the provided adapter
- Before charging, please turn off the power of the cleaning robot.
- The charging port should be cleaned before
- The red charging indicator light indicates that the battery is being
- The charging indicator light is green, indicating that the charging has
- Press the button to open the cleaning robot and put the cleaning robot into the
- When it touches the wall, it automatically moves in the opposite direction and starts cleaning the
- The cleaning robot will stop running when the power level is The cleaning robot will be pulled to the water near the edge of the pool when it is hooked from the handle with a special fishing hook.
- Power off operation: When withdrawing form the pool, the buzzer will turn on. Press the button to turn it After use, be sure to clean the filter.
Product cleaning
Product cleaning
FAQ
1. Everything is normal during operation, but the robot will get stuck
on the drain pipe or dry cover:
- Please remove the cleaning scraper for the water
2. The robot beeps and cannot operate after entering the water:
- Check the state of the charging indicator light;
- Restart the machine after recharging;
- If it still doesn’t work, please contact customer
3. No response after opening the robot:
- Plug in the charger and turn it on. If the robot beeps, continue charging for 1 hour before entering the water (please turn off the cleaning robot, beep Stop and charge). If it does not work, it is means that the battery is abnormal and needs to be
- If you still cannot open the machine after inserting the charger, please contact customer service to replace the components or machine;
- How to ensure that the robot can be successfully charged? Turn on the robot, put it in the pool, and see if it working
4. Even if the robot is fully charged, it only goes in one direction and
does not reverse when touching the wall:
- Check whether the baffle of the water outlet is stuck or blocked;
- Take out the control box and start it separately to see if there is any abnormality;
- If there is no other abnormality, the sensor is faulty, and the machine or control box needs to be
5. If the robot stops or gets stuck:
The product itself does not have the ability to overcome obstacles. You can preform the following operations:
- When stopping, check whether the cleaning scraper is stuck;
- Check whether the bottom of the pool is uneven;
- Check whether there are other objects stuck at the bottom of the
6. The robot’s running speed slows down and its suction becomes weak:
- Clean the filter screen and check whether the filter is too dirty. If yes, you are advised to manually clean the product and perform routine maintenance.
- The machine may be short of Clean it after it is full.
7. The charging port is corroded due to the electrolysis:
- Please note that after each use, wipe the charging pin, clean and dry it with a paper towel or cotton
- Install the waterproof plug after each
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inter- ference to radio or television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving
- Increase the separation between the equipment and
- Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
- Consult the dealer or an experienced radio/ TV technician for
Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in fixed/mobile(min2Ocm)exposure condition without restriction.
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>