Tasmor CR2025 USB Dream Color LED Strip User Manual
- June 14, 2024
- Tasmor
Table of Contents
Tasmor CR2025 USB Dream Color LED Strip
WHAT’S INCLUDE
Control with your phone
- Prepare all the required accessories before the installation.
- Peel off the adhesive strip from the back side of the LED STRIP LIGHT.
- Stick the LED STRIP LIGHTS on an even surface.
- The sensor of the lnfrared(IR) receiver must be placed at the visible range and should be less than 5M from the remote control. The round face of the IR sensor should be faced to remote control without obstacles.
- Connect the DC Plug of the USB cable into DC socket of the Control Box.
- Connect the USB 2.0 Plug of USB cable into USB socket of your TV or USB outlet of AC adapter (not included).
Specifications
Two different specifications of remote control (reference below)
Attention: Please pull out the plastic sheet at the bottom of the remote control before using it.
Batteries Installation for Remote control
Button cell battery (CR2025) is installed in the remote control.Pull out the PVC plate from battery door for the contact of battery before use.
To replace/ install a new battery into the remote control:
If the remote control is not operating properly or not responding at all, the
battery may be exhausted. Follow the below instruction to replace a new
battery. Open the battery door follow the instruction diagram on the back side
of the remote control. Insert 1x button cellbattery (CR2025). Battery should
be placed as shown on The diagram below.
Control with Your Phone
- Use any of the below methods to download the APP, or search “Magic Lantern” in the Apple or Google Play Store.
Compatible with: iOS & Android Scan the QR Code for quick download.
Pairing
Pair the LED STRIP LIGHTS with your smartphone
- Power on the LED strip lights.
- Keep the distance between your LED strip lights and samrtphone within 32.8 Feet.
- Activate the Bluetooth function on your smartphone and the lights will connect automatically.
After entering the APP interface, if Bluetooth is not enabled, “an application wants to enable the Bluetooth function of this device.” Click (Allow).
The LED strip supports cutting in different length and LED quantity. After cutting, the APP needs to set actual number of LEDs, and the position of setting was in the upper right corner (as shown in the figure), otherwise it will affect the use effect (for example, the LED strip you bought has 90 LEDs, which is cut 1 0 LEDs, then set the total number of points 90-10=80LED).
Interface of the APP
- A. Click to show the lamp list
- B. setting view Switch the color wheel
- C. Display the RGB value Click to manual adjustment view
- D. Click to shift the interface
- E. Click to display
- F. Lamp switch
- G. Adjust the color
- H. Click square icon to adjust the color
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>