HYPERKIN HDTV Cable for TurboGrafx-16 User Guide
- June 6, 2024
- HYPERKIN
Table of Contents
HYPERKIN® HDTV Cable for TurboGrafx-16® Quick Start Guide
Setting Up Your HDTV Cable
- Connect the HDTV Cable to the HD port on your HDTV.
- Plug the other end into the EXP BUS port on your console.
- Attach the included Micro cable to the HDTV Cable’s Micro port. Attach the other end to a 5V 1A USB power source (not included) to provide external power.
- BEFORE powering on your cable, make sure your aspect is configured. Moving the switch to the LEFT position indicates a 4:3 ratio. Moving the switch to the RIGHT position indicates a 16:9 ratio.
- Power on your console, and you’re all set!
For troubleshooting, contact us atSupport@hyperkin.com.
Cable Status Guide
The colored LED INDICATOR LIGHTS on your cable tells you your cable’s status. The BLUE light indicates that the cable is transmitting signal. The RED light indicates the cable is powered ON.
Both Blue and Red Light On = Cable is working
Red Light Only = Sleep Mode
If your cable has no signal for 10 minutes, it will switch to Sleep Mode.
Note: If your cable is not functioning correctly, an additional power source might be required. Connect the included Micro cable into the Micro port on the HD Cable and the other end into a 5V 1A USB power source. Power source is not included.
Please visit www.Hyperkin.com/warranty to register your official Hyperkin product for Hyperkin’s Warranty.
Statement of Compliance with EU Directive
Hyperkin Inc., located at 1939 West Mission Blvd, Pomona, CA 91766,
declares under our sole responsibility that the product, HDTV Cable for
TurboGrafx16®, is in compliance with the essential requirements and other
relevant provisions of Low Voltage Directive (LVD) 2014/35/EU, EMC Directive
2014/30/EU, and RoHS Directive 2011/65/EU and carries the CE marking.
The full Declaration of Conformity can be requested by emailing:
Email: compliance@hyperkin.com
Company Name: Hyperkin Inc.
Address: 1939 West Mission Blvd, Pomona, CA 91766
© 2019 Hyperkin Inc. Hyperkin® is a registered trademark of Hyperkin Inc. TurboGrafx-16® is a registered trademark of NEC Technologies, Inc. This product is not designed, manufactured, sponsored, endorsed, or licensed by NEC Technologies, Inc. in the United States and/or other countries. All rights reserved. Patent Pending. Made in China.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>