Aaobosi ZM1507 Slow Masticating Juicer Instruction Manual

: June 14, 2024
: Aaobosi

Table of Contents

ZM1507 Slow Masticating Juicer
Parts and Functions
Precautions for Safety Use
Parts and Functions
Method of Operation
How to assemble
Tips for Ingredients Selection
Maintenance
Safety Index
Trouble Shooting
Warranty
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Instrution Manual
Slow Juicer
ZM1507

220-240V 50/60Hz 150W
PLEASE READ INSTRU CTIONS CAREFULL Y BEFORE ASSEMBLY
RETAIN THIS MANUAL FOR FUTURE REFEREN CE

ZM1507 Slow Masticating Juicer

The device meets the requirements of Regulation 2014/30/EU as well as the applicable standards EN55014-1:2017 EN55014-2:2015, EN [EC 61000-3-2:2019, EN61000-3-3:2013+A1:2019

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible ham to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the retum and collection systems or contact the retailer where the product was LJ purchased. They can take this product for environmental safe recycling

Manufacturer: Zhongshan Jimi Electrical Appliance Co., Ltd
Add.: 9 of No.35 dadaozhong jixi Industrial, Xiaolan Town, Zhongshan, Guangdong, China

Company:YH Consulting Limited
Address:C/O YH Consulting Limited Office 147,Centurion House , London Road,’
Staines-upon-Thames , Surrey , TW18 4AX
Contact: Yingmin He Tel: +44 07514-677868 E-Mail: H2YHUK@gmail.com

Parts and Functions

Precautions for Safety Use

When using electrical appliances, basic safety precautions should always be followed, including the following:

Power of 120V~60Hz shall be supplied to this product. Please confirm your power supply before use.
Be sure to disconnect the power supply before dis-assembly/re- assembly or adjustment to this product.
In case of any damage to the flexible wire, to avoid any hazard, contact our customer service or send it to our authorized service center for replacement, and do not try to disassemble it without our authorization.
Prior to use, please check the power cable, plug, juice filter, Auger, chopper body, meat grinder and other parts, and in case of any damage, stop using this product and contact our customer service immediately without unauthorized dis-assembly or repair to avoid any potential hazard.
For need of any repair during use,return appliance to our authorized service facility for examination, repair or electrical adjustment.
Before connecting with power supply, make sure that any such removable parts as extractor body, auger, juice filter and extractor cover have been mounted inplace.
DO NOT put your fingers or other objects into the juicer opening while it is in operation. If food becomes lodged in the opening, use the plunger or another piece of fruit to push it down. When this method is not possible, turn the motor off and disassemble juicer to remove the remaining food.
The food material needs to be cut into proper pieces so as to pass through the inlet to extractor/chopper/grind. Any fruit/vegetable shall haveanyhardcore, seed, skinor shell removed before processing.
Proper amount of force shall be used to push the food material in, not excessive but sufficient to have it cut off exactly.
The juice filter, extractor cover, or auger may be dyed by the juice during operation, which is a normal phenomenon and has no effect on edibility and does no harm to health.
This product is equipped with intelligent protection chips, making it stop automatically for every 20 minutes’ operation. And in such case, restit for 20-30 minutes before restarting it, so as to cool the motor down and prolong product servicelife.
This product is designed to limit the flow rate. During processing of any hard material, the motor will be locked and the current will rise up.
When the current goes higher than 1.3A, the equipment will beep and the motor will stop operation for over-current protection and extension of life span.
In case that current limit protection is triggered or the motor is locked and stops automatically, disconnect the power supply and keep the switch in position “0”, and press Rotate Backwards button on the power switch, and then discharge the food material and then press Rotate
Forwards to restart the machine. If the problem continues, it is recommended to remove any food material inside auger before restart so as to protect the motor.
After the completion of operation, remove any removable part only after the motor/auger/shredder/slicer/grinder screw has stopped rotating and the power has been disconnected.
Any part in contact with food material is clean, safe and reliable in compliance with related food hygiene codes.
To protect against risk of electrical shock, do not put the motor base in water or other liquid.
Do not use any steel wool, abrasive cleaning agent or corrosive liquid such as gasoline or acetone to clean this product.
This product should be stored in a place that children can’t reach. Not allow persons with unsound extremities and sensation or mental disorders and persons who are short of related experience and knowledge( including children ) to use or play with this product.
This product is used for individual or family only.
This product is of Class-I protection grade, and the socket used for it must be grounded properly.

Parts and Functions

No.	Part name	Function
(1)	Power cord	It is used for connecting the power supply to provide power.
(2)	Main body	As a main part and the power source of the appliance,
(3)	Power switch	It controls the operating statuses of the appliance.
(4)	Locking Button	It is used for locking the drum to prevent it from

getting loose from the main body during use.
(5)| Drum| It is a main part for juicing. Food ingredients are loaded from the Feed Chute at the top and then discharged in forms of juice and pulp via the juice outlet and the pulp outlet respectively.
(6)| Juice strainer| By means of breaking in with the Auger, it is used for grinding and filtering the extracted food ingredients to get juice
(7)| Auger| As a main part for juicing, it is used for conveying food ingredients and grinding them by breaking in with the juice strainer or the squeezer.
(8)| End cap| It is used for grinding food ingredients by breaking in with the Auger(For fruits and vegetables).
(9)| Juice container| It is used to hold and collect juice.
(10)| Pulp container| It is used for loading Pulps.
(11)| Plunger| It is used for squeezing the fed food ingredients gently for their full contact with the auger and higher juice extraction efficiency.

Method of Operation

Priorto firstuse,Please thoroughly clean any parts in contact with food material. (See Section [V. Maintenance for more details)

| Switch operation instructions:
“SOFT”: it is used for juicing soft food ingredients.
“HARD:it is used for juicing hard food ingredients.
*0″ : Close and stop “Rev” : It is used when pulp discharge blocked or the motor is locked
---|---

How to assemble

Connect the juicing body and the main body:1.Have the triangular aligning sign “V¥” on the juicing body align with the aligning “unlocking triangular sign” on the main body and then put the juicing body into the main body (the three clips on the juicing body will realize alignment).Then turn the juicing body anticlockwise. When there is a click, it suggests that the connection is finished.
Have the hexagonal shaft of the Auger align with the hole on the main body and push it horizontally until it reaches the bottom (when alignment fails, just turn the Augers lightly).
Fit the larger-hole end of the juicer strainer into the tail of the Auger and push it while the three clips of the juicer strainer align with the three clamping slots in the drum. (The juice straine
r is used with the juicing button in the rear only. This function is used for juicing.)
Place the end cap onto the drum by aligning the triangle alignment mark “¥” on end cap with the unlock triangle mark on the drum, and then rotate the end cap counter clockwise.
Put the Juice container in the corresponding groove on the main body and have its opening align with the bottom of the juice outlet of the drum.
Put the pulp container below the pulp outlet of the drum.
Connect the power supply for use of the appliance (make sure the switch is on the OFF position before the power supply is connected).
Wash vegetables and fruits, cut them into blocks fitting the size of the feed port and put them on the tray.
After the “SOFT or HARD”” button of the switch is pressed, the appliance will begin to run for 10 minutes or a shorter time.
Put food ingredients into the feed chute on the drum and then push the food ingredients with help of the plunger.

Tips for Ingredients Selection

FRUIT JUICE EXTACTOR
Efficiently juices hard and soft fruits: even citrus fruits, usually one of the hardest fruits to juice.
Jam can not be achieved, some fruit can not squeeze juice (such as bananas, mangoes, dried fruit, sugar cane, etc.).
VEGETABLE JUICE
Cut vegetables to strips(less than 4inch/10cm) .
Juices all kinds of vegetables including carrots, beets, celery, peppers, and radishes without destroying the natural flavor and nutrition benefits.
Fresh taste and full nutrition are guaranteed with this unique extraction process.
WHEATGRASS AND LEAFY GREENS
Cutitto strips(less than 4inch/10cm) .
Wheat grass, kale, cabbage, spinach and pine tree needles are just some of the natural products that can be juiced with the Amzchef juicer. Enjoy the best that nature offers in raw foods of all kinds and juice them for full nutritional benefits.

Instructions on Selection of Fruits

Select fresh fruits and vegetables, which contain more juice. The proper fruits include: pineapple, beet root, celery stalk, apple, cucumber, spinach, melons, tomato, orange and grape.
Thick skin on fruits such as orange, pineapple and raw beet root instead of thin skin on fruit/vegetable needs to be removed. Seedsin oranges should be removed as well, which may make the juice taste alittle bitter.
Concentration of juice extracted from apple depends on what type of appleis selected. Juice extracted from juicier appleis less thick, so select the proper type of apple depending on your desired juice concentration.
Justextracted apple juice will turn brown very soon, and this process can be slowed by adding drops of lemon juice into it.
Leaves and stems (such as those of lettuce) can be putinto the extractor to extractjuice.
The typical nutrient ingredient contained in fruits/vegetables are shown below:

Fruit/Vegetable	Vitamin/Mineral	Calorie
Apple	Vitamin C	0.44LB (200g) =150KJ(72 calorie)
Apricot	Dietary fiber and potassium	0.07LB (30g) =85KJ(20 calorie)
Beet	Folic acid, dietary fiber, Vitamin C and potassium	0.35LB (160g)

Maintenance

Before cleaning this product, be sure to shut down the switch to disconnect the power supply.
Clean this product after using it.
The Housing cannot be washed under water, and must be cleaned with twisted wet clothinstead.
Before storing it, make sure this productis clean and dry.
Disassemble this product to wash the components by the following steps:

| 1| Take down the plunger
---|---|---
| 2| Press the locking button on the side of the drum and turn the drum clockwise at the same time to take out the drum.
The drum cannot be dismantled if the button is not pressed.
| 3| After taking down the drum, take down the juicing button (or the noodle button and so on), the tray, the juice strainer (or the end cap) and the auger in order. The dismountable parts may be flushed with clean water.

WARNING
Do not immerse the motor base in water or any other liquid. Do not use water jet to clean the motor base.

Safety Index

Product Name	Slow Juicer
Model	ZM1507
Rated Voltage	220V-240V ˜
Rated Power	150W
Rated Frequency	50/60Hz
Continuous Operating Time	510 minutes
Interval Time	10 minutes

Trouble Shooting

Fault
Phenomenon| Analysis of cause| Fault resolution
---|---|---
After connecting power supply and turning on the switch, the product fails to
work| 1.After turn on the machine, wait for 1s, it will work. It is
normal.
2.After 1s, it still no work, maybe poor contact between plug and socket| Re- plug it properly
1. Replacethesocketandtry again, or contact after
Sales Support Email: info@iamzchef.com
During the early uses, the motor generates unpleasant smell| It is a normal phenomenon| If this phenomena occurs frequently, send it to our authorized service center nearest to you for inspection.
This machine stop during operation| 1.Too lowvoltage
2.Excessiveamountof food material has been loaded
3.The machine has operated continuously for long time.| 1.Check whetherthe voltage is too low
2.Disconnect the power supply and remove excessive food material
3.It is a normal phenomenon and the motorwill resume after a breaktime.
Noise is generated during
operation.| 1.The machine operates in an unbalanced state due to failure to mount auger orjuice filter in place.
2.The starting motor in the frame has been damaged.| 1. Mount auger or juice filter in place or Contact after Sales Support Email: info@iamzchef.com

Warranty

Thank you for purchasing our product, which has been made to meet high quality standards. The manufacturer’s warranty covers the product for a period of 24 months from the date of purchase against manufacturing faults.
All Amzchef warranties are automatically kept track of in our system, so there is no need to register your product.
For 6month extra free of charge warranty, please register at website www.iamzchef.com or fill in and take picture of bellow Warranty Card sending to info@iamzchef.com.

Due to continuous product improvement, we reserve the right to change the product specification without prior notice.