HUPEJOS V7 360° Dash Cam 4 Channel Quad Camera User Manual

V7 360° Dash Cam

User Manual

WHAT’S IN THE BOX ?

Use Reminder

1. Please read this instruction manual carefully before using the camera. It contains important information for your safety as well as operating and maintenance instructions.
2. Follow all safety precautions in order to prevent damage due to improper use of the camera.
3. You should not install this dash camera at a place that would obstruct or reduce a driver’s view. Make sure your usage complies with pertinent vehicle codes of your state, province, territory or country.
4. You should avoid extended exposure of the dash cam to direct sun light or extreme temperatures (either high or low temperature) which tend to degrade or damage the unit and its normal functionality.
5. You should examine, check and verify the dash cam at least every 6 months, including the memory card, to ensure the video reception and recording are working properly for each use, you should verify that the dash cam unit, the visible lights and the audible sounds are working normally.
6. Do not try to open the cover or try to repair it yourself. If the accessories for this device have any problem, please contact the seller for assistance.
7. Pay careful attention when cleaning the lens surface. Use a soft, moist cloth to clean the lens to avoid compromising video quality.
8. You should use the dash cam unit in the way it is intended. You should not use the dash cam unit in a way that would be illegal or that tends to physically damage the unit, or tend to cause danger to the safe operation of the vehicle or the occupants.
9. This device is intended to be used inside the vehicle only.
10. Do not expose this product to rain, moisture or water under any circumstances or it will result in external or internal damage.
11. Do not operate or install the camera while driving, or attempt to change any setting etc.
12. If any damage is caused by failure to follow the instructions, the warranty will be voided.

Getting Started

1. Before installation, please check the accessories carefully to ensure that the product and accessories are correct and complete.
2. In order to ensure that the device is running well, please format the micro SD card first before use.
3. During installation, be sure not to insert the car key into the power supply, and donot insert or remove any machine accessories like microSD card or rear camera when the dash cam is powered on. These actions should be completed when power is turned off.
4. When the car key is plugged into the vehicle, the dash cam will automatically turn on. Please check whether the function of power on/off, the cameras display is normal.
5. If you need to download the recording videos and images, please turn off the camera first before removing the microSD card.
6. You must use U3 high-speed card (recommended capacity 8GB-256GB),lower than U3 will cause problems like video stutter, black screen, and video cannot be recorded or cannot be played.
7. For some mobile phone models, if find that the TsCam APP cannot be connected to the preview, please turn on the airplane mode of the mobile phone and try.

Product Overview

1.TYPE C power port
2.Rear camera head port
3.The up button
4.The menu button
5.The down button
6.The power button
7.TF card slot| 8.Front camera
9.Inside Left Camera
10.Inside Right Camera
1LIR lamp
12.Display
13.Working indicator light
14.Bracket
---|---

Operation Settings

Work Indicator

Blue indicator light

1. Blue light is visible on the camera is plugged into the supply.
2. The indicator light blue light blinks on the Camera is recording.

Power On and Off
The camera will automatically turn on when the vehicle is started and turn off when the vehicle is turned off.
Short press the button once to turn on the camera, and then long press it again to turn off the camera.

When plugging in the car charger, the camera will automatically turn on and automatically start recording. When unplugging the car charger, it will automatically save the current video file and immediately shut down.

Insert the memory card
Push the TF memory card straight into the slot in the direc-tion of the screen print until you hear a “click” sound.
Remove the card: Push the TF memory card forward, and the card will be removed when it s ejected.
Note: Removing the TF card in the video state may reduce the file and damage the life of the TF card, please turn off the dashcam first before inserting and removing the TF card

SD card record files are described
SD Card name: Storage file
Event: Store video files that are locked in an emergency or manually

Normal: Store of conventional driving video files
Photo: Store snapshots
Parking: Store video files recorded by parking surveillance cameras
Share: For the reserved function, no files are stored Secondary folder
A/B/C/D
A: Store video/pictures of front shots
B: Store video/pictures of left shots
C: Store video/pictures of right shots
D:Store the video/picture of the rear shot

V7 power tools

1. Cig Charger
   Note: It is best to use the power cord that comes with our products, or our professional hardwire kit.

2. Hardwire Kit with radar
   (Required for Parking Mode. Prevents car battery drain)(Not included, purchased separately)

Function display of dash cam display Main Interface

Video mode: short press the up button to stop the video, and then press the menu button to enter the main interface
Dash Cam: Driving recorder mode
Playback: Playback video or picture mode
Sound Record: Recording switch for Audio recording
Settings: System Settings

Number : Function description of the video recording interface

1. When you stop recording video, the time of recording will disappear automatically.

2. Resolution: Video resolution:4-way 1920%1080

3. Indicates that the sound recording function is enabled
   Indicates that the sound recording function is disabled.

4. WiFi function is not enabled.
   WiFi function is enabled.
   WiFi function is Connected.

5. SSID number and WiFi password

6. Current system time

7. The currently recorded video is protected with alock of 20 seconds.

8. Front camera screen

9. Rear camera screen

10. The left camera screen showing inside the car

11. The right camera screen showing inside the car

Playback operations and settings Button operation during playback

Playback file preview screen – icon status.

1. Video/picture switch key: Long press the down button to switch from video file preview to picture file preview
2. Menu: Long press the menu button to enter the menu mode
3. Previous page: Short press the up button to view the previous video/picture.
4. Next page: Short press the down button to view the next video/picture.
5. Long press the down button: To return to the video recording mode

Volume: 0~100 [Default value: 50] Video type: Normal/Parking mode/Emergency
Camera: A/B/C/D
Delete: Delete one or all of them
Protect: Protects selected files/deprotects selected files/Protects all files/deprotects all files

Sound Record:
Press “M” button to turn on or off the Audio recording function Sound Record:
Indicates that the recording function is turned on when recording video
Indicates that the recording function is turned off when recording video

Settings:

Wi-Fi: ON(default)/ OFF
1440P+1080P+1080P/1080Px4(Default)
IR Led: On/Off / Auto (Default)
Note: When the scene is dark, it automatically opens, and when the scene is bright, it closes.
G-sensor: sensitivity setting, it works in parking monitoring mode, high/medium (default) low sensitivity / OFF
Parking: When parking, if there is a collision when opening, the DASH CAM will automatically start recording for 30 seconds and then close it. High/medium/low sensitivity can be set
language :English(Default)
Screen Saver: Off (default) You can set 1 minute to automatically close the screen and 3 minutes to automatically close the screen
Clock Settings: Set the date and time
Fomat card: Select whether to format the memory card (Format the memory card before using the dash cam)
Reset: Select whether to restore factory Settings

Specifications

machine before it can be used for the first time.
9. Multi-language support:| English
10. WIFI APP:| Support
11. Standby current:| 860mA
12. DDR:| DDR3 26
13. Battery:| None
14. Lens:| 6G F/NO 1.8
15. SENSOR:| 2 megapixels
16. Lens angle:| 150 degrees
17. Display specifications:| 3.16-inch IPS
18. Display resolution:| mp4
19. G-SENSOR:| three-axis gravity sensor
20. Speaker specifications:| 8R1W
21. IR infrared fill light:| 8pcs 940
22. Static current:| 20uA

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>