PRiMY PR-777-Z Drafting Chair Instruction Manual
- June 14, 2024
- Primy
Table of Contents
PRiMY PR-777-Z Drafting Chair
Instructions for Use
Thanks for purchasing our products. Please read this manual before assembly. And please assemble in order. After the assembly, keep the instructions properly. Make sure all the parts are included (13 kinds in total).
Accessories List
Notice
[If any questions, contact [email protected] [email protected]
- Do not stand in this chair or use the chair as a step ladder use it as a chair only. This chair is designed for one person to use at a time.
- This chair is designed for one person weighing up to 250Ib(113kg).
- Do not use this chair unless all bolts, screws and knobs are firmly secured.
- Check all bolts, screws and knobs every 90 days. Tighten if any are loose.
- Failure to follow these instructions may result in serious injury or death of yourself and the people around you.
- Some of the parts are heavy and/or have shaped edges, please install them carefully to avoid hurting you and the people around you.
Assembly Instruction
Please assemble in a wide and flat place.
Step 1
Take out Split Base Tube (3) and Central Base Tube (4). Insert Split Base Tube
(3) into Central Base Tube (4) as shown. You can see there are screw holes.
Align with the holes, tighten Screws M6X20mm (8) with Hexagon Wrench (12) to
fix 5 Split Base Tube (3) to Central Base Tube (4). Repeat it five times.
Step 2
Take out Castors (5) and Air Rod (6). Insert Castors (5) into part of Step 1
as shown. There are 5 Castors (S) that need to be inserted. Insert Air Rod (6)
into the hole of the Central Base Tube (4) as shown. Put it aside and we’ll
use it in Step 6.
Caution: Confirm Castors (5) must be inserted deeply. Otherwise, the
castors could easily fall out and the chair could fall.
Step 3
Insert the Foot Ring (13) into the assembled Air Rod (6) at your desired
height. But at least one inch from the top of the outer circle of the Air Rod
(6) as shown. Please follow the shown direction of the arrow to tighten the
knob by hand on the Foot Ring (13) until the Foot Ring (13) is fixed.
Step 4
Fix the Base Plate (7) to the bottom of the Seat Cushion (2). Tighten the
Screws M6X18mm (9) with Hexagon Wrench (12) firmly.
Step 5
Fix the Base Plate (7) to the bottom of the Seat Cushion (2). Tighten the
Screws M6X18mm (9) with Hexagon Wrench (12) firmly.
Step 6
Pick up the Step 3’s Air Rod (6) and Central Base Tube (4). Insert the AirRod
(6) into Step S’s Base Plate (7). There’s a hole in the middle of BasePlate
(7). Press the Seat Cushion (2) from top to bottom, and use your whole body’s
strength to insert it firmly, the assembly is complete now.
Caution
If the Air Rod (6) doesn’t inserted into Base Plate (7) firmly, it’s likely
to fall off when the chair rises.
Activate Your Warranty Now!
Primy guarantees you a pleasant buying experience. Please scan the QR code
to activate your warranty so that you can enjoy priority and better after-
sales service