trueCABLE Cat6A Toolless Keystone Jack Installation Guide
- June 14, 2024
- trueCABLE
Table of Contents
SHIELDED TOOLLESS
KEYSTONE JACK
Cat6A Toolless Keystone Jack
- Remove 2.5″ of cable jacket, carefully avoid nicking any conductors. Do NOT remove foil shield.
Fold the cable shield backwards & wrap the drain wire around. Remove spline, PE tape, or waterproof tape. 
- Insert conductors into either T568A or T568B color sequence.
- Carefully flush cut conductors from sides of termination cap.
- Carefully and evenly seat the termination cap fully into the keystone jack.
- a Close the jack housing. There will be a snap sound.
6b RECOMMENDED: use trueCLOSE pliers to apply force at the very rear.
- Trim the zip tie.
- All done!
Comprehensive How-To available on our Cable Academy
800.719.8277
truecable.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>