NOVUS NVB-6030JB Wall/ceiling mount bracket indoor/outdoor User Guide
- June 4, 2024
- Novus
Table of Contents
NVB-6030JB, NVB-6035JB, NVB-6040JB – user’s manual ver. 1.1
Introduction
Wall/ceiling internal/external mount brackets NVB-6030JB, NVB-6035JB and NVB- 6040JB are designed for IP camera 6000 series. A complete list of compatible cameras is available in the product data sheet on http://www.novuscctv.com/en.
Package contents
| Wall/ceiling mount bracket | 1 pc |
|---|---|
| Mounting screws/pins | 1 set |
| Mounting template | 1 pc |
| Foam gasket | 1 pc |
| Cable gland | 1 pc |
Technical specification
| Bracket type | Wall/ceiling mount bracket, internal/external |
|---|---|
| Material | Aluminium |
| Colour | White |
| Load capacity | 10 kg |
| Dimensions | Detailed dimensions showed on a diagram |
| Weight | 0,4 kg – NVB-6030JB |
0,5 kg – NVB-6035JB
0,6 kg – NVB-6040JB
Installation manual
-
Pick a suitable location and provide all necessary wiring in desired bracket mounting place.
-
Mark 4 mounting holes and drill them in selected locations (optionally use a mounting template).
-
Stick the foam gasket to the back side of the bracket (base), unscrew the bracket base, and cover.
-
Put wiring through cable gland, then mount cable gland in one of the holes in bracket base. Plug unused holes with attached end caps and if required, please seal it with appropriate sealing mass. Tighten the cable gland until feels resistance.
-
Screw the base of the bracket to the wall. It is recommended to mount the bracket so the hole from the side is directed downwardly.
CAUTION! Please note that the wall must have enough strength to support the bracket with the camera.
If the installation involves cameras 5DN3625AV/940IR-1P, 5V-6502M/F, 2V- 6502M/F: -
a. Connect the camera cables and wires into the base of the bracket.
-
a. Screw the camera to the base of the bracket. The bracket cover is not used in this case.
If the installation involves other cameras:
6a. Put all cables from the camera through the central hole of the bracket cover.
7a. Screw the camera to the cover of the bracket using screws from accessories, and use a gasket from the cover of the bracket to keep a degree of protection. -
a. Connect the camera cables and wires into the base of the bracket.
-
a. Screw the cover of the bracket (with camera) to the base of the bracket.
CAUTION! To keep a degree of protection seal every hole and possible leak place using additional sealant, both in bracket and camera.
NVB-6030JB, NVB-6035JB, NVB-6040JB – user’s manual ver. 1.1
External dimensions (in millimeters) for NVB-6035JB and NVB-6040JB
NVB-6030JB, NVB-6035JB, NVB-6040JB – user’s manual ver. 1.1
AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o. ul. Puławska 431, 02-801 Warszawa,
Polska
tel.: 22 546 07 00, faks: 22 546 07 59
www.novuscctv.com
2021-07-02 DK MK
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.