COMMSCOPE NVX-UMC-NN-NN-CC1 NOVUX Fiber Optic System Installation Guide
- June 14, 2024
- CommScope
Table of Contents
COMMSCOPE NVX-UMC-NN-NN-CC1 NOVUX Fiber Optic System
Kit contents
N° | Description | Qty |
---|---|---|
1 | Mounting clips | 1 |
Note: Mounting hardware (such as screws, plugs, washers) should be selected according to intended mounting surface (not included in the kit).
Mounting clips installation
- Break off the two mounting clips.
- Note: the two clips are not identical. Make sure to mount the clips in the correct position. Small hole facing upwards.
- Mount the clips on the base at both sides (top and bottom).
Wall mounting
- Using the mounting clips as a template, mark the mounting screw locations on the selected surface for the installation.
- Install wall plugs first, then position the closure with the mounting tabs against the surface. Continue with the washers and the screws to secure the closure onto the surface.
© 2023 CommScope, Inc. All Rights Reserved
All trademarks identified by ® are registered trademarks in the US and may be
registered in other countries. All third party product names, trademarks and
registered trademarks are property of their respective owners. This product
may be covered by one or more U.S. patents or their foreign equivalents. For
patents, see www.cs-pat.com. This document is not
intended to modify or supplement any specifications or warranties relating to
CommScope products or services. Visit our website or contact your local
CommScope® representative for more information.
www.commscope.com.
For technical assistance, customer service, or to report any missing/damaged
parts, visit us at: http://www.commscope.com/SupportCenter