COMMSCOPE PPL-2U-HD-FX-OPEN Propel Fixed-Open Panel User Guide

COMMSCOPE PPL-2U-HD-FX-OPEN Propel Fixed-Open Panel

Product Information

The Propel Fixed Open Panel is available in two sizes, 1RU or 2RU. The panel is shipped with a mounting bracket that can be relocated to 3.5, 6, or 9 offset positions for rear of rack mounting. The panel comes with a panel fastener pack and requires a #2 Phillips screwdriver for installation.

PARTS LIST

NOTE: In most illustrations, this document shows the 2RU panel (highlighted in yellow at right). 1RU is similar in function.

INSTALLATION

1. Removing Panel from Box
   Open the box and remove the Propel panel and other items from the box. Check the Parts List to ensure all items are present.

2. Selecting Panel Mounting Option Bracket can be relocated to 3.5″ or 6″ offset positions, or 9″ offset for rear of rack mounting.

3. 3” Offset Position
   Panel is shipped with bracket in 3″ offset position using holes marked “1 ”.

4. 3.5” Offset Position
   To mount bracket at 3.5″ position remove screws from holes marked “1” and remount bracket using unmarked holes.

5. 6” Offset Position
   To mount bracket at 6″ offset, remove 4 screws from holes marked “1” and rotate bracket 180 degrees. Reinstall 4 screws in holes marked “1 ”.

6. 9” Offset Position
   To mount bracket at 9″ offset, remove the 4 screws from holes marked “1”, rotate bracket 180 degrees, reposition bracket at rearward position, and reinstall 4 screws in holes marked “1”.

7. Mounting Panel on Frame
   Mount the panel by installing the provided mounting screws through the panel mounting bracket and into the rack mounting holes.

8. Opening and Closing Panel
   Grasp cover at upper outside corner on each side and pull it out allowing it to swing down. To close cover, swing it up until it clicks into place.

9. Installing Module or Cassette

10. Installing and Routing Cables

11. Installing and Routing Patch Cords
    At the front of the panel, route patch cord through the corresponding upper or lower opening of the integral patch cord manager (one each at the front corners of the panel). Repeat for each patch cord.

PRODUCT INFORMATION AND TECHNICAL SUPPORT: http://www.commscope.com/SupportCenter

PRODUCT PATENTS: http://www.cs-pat.com

© 2023, CommScope, Inc. All Rights Reserved.

References

• Support options from CommScope
• Product Patent

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>