COMMSCOPE L5-CLAMP-4B Kwik Clamp Hanger Installation Guide
- June 13, 2024
- CommScope
Table of Contents
Installation Instructions
Kwik Clamp™ Hangers
for Fiber, Power, Hybrid and Coaxial Assemblies
Bulletin 7857216 Revision D Page 1 of 1
CommScope Infrastructure Academy offers installation training.
Description
The Kwik Clamp hanger consists of a clamping body, which mounts on a flat 3-25 mm section or 8-25 mm round pipe. They have two support blocks that surround the cable. The assembly is secured by compressing the blocks against the tower member with a bolt. Hanger kits are available for 1, 2, 3 or 4 cable runs.
Flat / Channel mounting
Round member mounting
Step 1: Place the clamp body and first saddle (preferably from above)
around the cables and hook it on the support.
Step 2: Insert second saddle (preferably from above). Repeat the steps
1-2 for each cable.
Step 3: Tighten the self-locking screw to 5 N·m torque.
Recommended Maximum Hanger Spacing, 1.83 m with a Wind Speed of 137 km/h and
No Ice.
CommScope
3642 E US Highway 70, Claremont, NC 28610 USA
828-324-2200
800-982-1708
www.commscope.com| Technical Support
+1 888 297 6433, Option 3 (Toll Free US and Canada)
+1 49-9099-69-333
https://www.commscope.com/wisupport (open a ticket)
---|---
Notice: CommScope disclaims any liability or responsibility for the
results of improper or unsafe installation, inspection, maintenance, or
removal practices.
© 2023 CommScope
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>